Alternator and Regulator
Show/hide table
无负载电压 | 输出电压 | 13.8 至 14.8 V [25° C(77° F)温度下],4000 min-1(rpm) |
定子 | 电阻 | 低于 1.0 Ω |
转子 | 电阻 | 2.8 至 3.3 Ω |
滑环 | O.D. | 新 - 22.7 mm(0.894 in) |
允许限制 - 22.1 mm(0.870 in) | ||
刷子 | 长度 | 新 - 18.5 mm(0.728 in) |
允许限制 - 5.0 mm(0.20 in) |
Caterpillar Information System:
Procedure to Test the Position Sensor of a Hydraulic Cylinder {1439, 7562} Procedure to Test the Position Sensor of a Hydraulic Cylinder {1439, 7562}
C1.5 and C2.2 Industrial Engines Multiposition Switch Setup
C175-16 Engine Turbocharger Turbine Temperature Is High
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Normal Operation
C175-16 Engine Prelubrication Pump Problem
793F and 797F Off-Highway Trucks Power Train Electronic Control System MID 081 - CID 0674 - FMI 08
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Operator Control Switch (Switch to Ground) - Test
C175-16 Engine Oil Temperature Is High
C175-16 Engine Oil Pressure Is Low
C175-16 Engine Oil Filter Differential Pressure Problem
Testing for Excessive Cylinder Blowby in 3500 Engines{1000, 1100, 1223} Testing for Excessive Cylinder Blowby in 3500 Engines{1000, 1100, 1223}
2012/10/04 An Improved Hand Operated Fuel Priming Pump Is Available for Certain Truck Engines {1258}
C2.6 and C3.3B Engines for Caterpillar Built Machines Electric Starting Motor
G3512H and G3516H Generator Set Engines Transfer Gearbox - Remove
G3512H and G3516H Generator Set Engines Transfer Gearbox - Install
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Engagement Pressure for the Transmission Clutch - Calibrate
Installation Procedure for Product LinkTM PLE640 Systems{7606} Installation Procedure for Product LinkTM PLE640 Systems{7606}
C18 Marine Engine Crankshaft Vibration Damper - Inspect
C18 Marine Engine Plate Locations and Film Locations
Alternator - Bosch K1/N1 General Information
Alternator - Bosch K1/N1 Service Tools
C1.5 and C2.2 Industrial Engines Customer Specified Parameters
Alternator - Bosch K1/N1 Diode Assembly - Test
C1.5 and C2.2 Engines for Caterpillar Built Machines System Configuration Parameters