Diode Assembly - Test
Show/hide table
 | |
| Illustration 1 | g03279456 |
Diode Assembly (1) Terminal (2) Terminals | |
- Remove the diode assembly from the alternator.
- Set the multimeter to the diode scale.
- Connect the multimeter leads across terminal (1) and one terminal (2) .
- Record the multimeter reading.
- Reverse the multimeter leads.
- Record the multimeter reading.
Expected Result: One reading is "0L" and the other reading is .4 to .9 volts.
Results:
OK - One reading is "0L" and the other reading is .4 to .9 volts. The diode is normal. Repeat steps 3 through 6 for the other terminals (2). If all of the diodes are normal, the diode assembly is normal. STOP.
NOT OK - Both readings are "00". The diode assembly is shorted. Replace the diode assembly. STOP.
NOT OK - Both readings are "0L". The diode assembly is open. Replace the diode assembly. STOP.
Caterpillar Information System:
C1.5 and C2.2 Industrial Engines Customer Specified Parameters
Alternator - Bosch K1/N1 Service Tools
Alternator - Bosch K1/N1 General Information
C18 Marine Engine Plate Locations and Film Locations
C18 Marine Engine Crankshaft Vibration Damper - Inspect
Installation Procedure for Product LinkTM PLE640 Systems{7606} Installation Procedure for Product LinkTM PLE640 Systems{7606}
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Engagement Pressure for the Transmission Clutch - Calibrate
G3512H and G3516H Generator Set Engines Transfer Gearbox - Install
G3512H and G3516H Generator Set Engines Transfer Gearbox - Remove
C2.6 and C3.3B Engines for Caterpillar Built Machines Electric Starting Motor
C2.6 and C3.3B Engines for Caterpillar Built Machines Alternator and Regulator
Procedure to Test the Position Sensor of a Hydraulic Cylinder {1439, 7562} Procedure to Test the Position Sensor of a Hydraulic Cylinder {1439, 7562}
C1.5 and C2.2 Engines for Caterpillar Built Machines System Configuration Parameters
C1.5 and C2.2 Engines for Caterpillar Built Machines Replacing the ECM
3516B and 3516C Engines For MT4400D AC Off-Highway Trucks Oil Level - Test
C18 Marine Engine Coolant Level - Check
C32 Auxiliary Engine Derating Strategy
C1.5 and C2.2 Engines for Caterpillar Built Machines Flash Programming
C1.5 and C2.2 Industrial Engines Acceleration Is Poor or Throttle Response Is Poor
C1.5 and C2.2 Industrial Engines Engine Speed/Timing Sensor Circuit - Test
C1.5 and C2.2 Engines for Caterpillar Built Machines Alternator Is Noisy
C1.5 and C2.2 Engines for Caterpillar Built Machines Alternator Problem
C1.5 and C2.2 Engines for Caterpillar Built Machines Battery Problem
2013/01/04 New Instrument Panel Box Gp Is Now Available as Service Replacement for Certain Cat® Engines {7451, 7490}