Electric Starting Motor
Show/hide table
转接器 | O.D. | 新 - 32.0 mm(1.26 in) |
允许极限 - 31.4 mm(1.24 in) | ||
云母 | 咬边 | 新 - 0.50 mm(0.020 in) |
允许极限 - 0.20 mm(0.0079 in) | ||
刷子 | 长度 | 新 - 18.0 mm(0.709 in) |
允许极限 - 11.0 mm(0.433 in) | ||
刷座 - 固定架 | 电阻 | 无穷大 |
转接器 - 电枢线圈芯 | 电阻 | 无穷大 |
转接器 - 线段 | 电阻 | 0 Ω |
励磁线圈引线 - 刷子 | 电阻 | 0 Ω |
励磁线圈刷 - 轭 | 电阻 | 无穷大 |
Caterpillar Information System:
C2.6 and C3.3B Engines for Caterpillar Built Machines Alternator and Regulator
Procedure to Test the Position Sensor of a Hydraulic Cylinder {1439, 7562} Procedure to Test the Position Sensor of a Hydraulic Cylinder {1439, 7562}
C1.5 and C2.2 Industrial Engines Multiposition Switch Setup
C175-16 Engine Turbocharger Turbine Temperature Is High
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Normal Operation
C175-16 Engine Prelubrication Pump Problem
793F and 797F Off-Highway Trucks Power Train Electronic Control System MID 081 - CID 0674 - FMI 08
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Operator Control Switch (Switch to Ground) - Test
C175-16 Engine Oil Temperature Is High
C175-16 Engine Oil Pressure Is Low
C175-16 Engine Oil Filter Differential Pressure Problem
Testing for Excessive Cylinder Blowby in 3500 Engines{1000, 1100, 1223} Testing for Excessive Cylinder Blowby in 3500 Engines{1000, 1100, 1223}
G3512H and G3516H Generator Set Engines Transfer Gearbox - Remove
G3512H and G3516H Generator Set Engines Transfer Gearbox - Install
CX48-P2300 Petroleum Transmission Power Train Electronic Control System Engagement Pressure for the Transmission Clutch - Calibrate
Installation Procedure for Product LinkTM PLE640 Systems{7606} Installation Procedure for Product LinkTM PLE640 Systems{7606}
C18 Marine Engine Crankshaft Vibration Damper - Inspect
C18 Marine Engine Plate Locations and Film Locations
Alternator - Bosch K1/N1 General Information
Alternator - Bosch K1/N1 Service Tools
C1.5 and C2.2 Industrial Engines Customer Specified Parameters
Alternator - Bosch K1/N1 Diode Assembly - Test
C1.5 and C2.2 Engines for Caterpillar Built Machines System Configuration Parameters
C1.5 and C2.2 Engines for Caterpillar Built Machines Replacing the ECM