C1.5 and C2.2 Industrial Engines Caterpillar

The multi-position throttle switch is an optional throttle input. A maximum of two switches can be used. Two switches will allow a maximum of four speeds to be selected.

When the multi-position switch is selected as the "Throttle Type" on the "Throttle Configuration Screen" of the electronic service tool, additional information is required.

Number of Switch Inputs

This parameter is the total number of switches that will be used. The switches may be individual switches or a ganged rotary switch.

Table 1

Range	Default
1 to 2	0

Physical Position

This parameter is non-programmable. The parameter is used to signify the position of the rotary switch.

Input 2, Input 1

The number of these non-programmable parameters that are visible depends on the value that is programmed into the "Number of Switch Inputs" parameter. "Open" signifies that the switch is in the OFF position. "Ground" signifies that the switch is in the ON position.

Physical Position Enabled

If "Yes" is selected, the ECM sets the engine rpm to the value in "Engine Speed" for the switch configuration for that Physical Position.

Table 2

Value	Default
No Yes	No

Logical Position

The Logical Position is the order that is required by the user for a unique Physical Position.

Table 3

Range with Four Switches	Default
1 to 4	1

Engine Speed (in RPM)

The "Engine Speed" is the programmed engine rpm for a particular position of the multi-position throttle switch.

If the ECM detects a switch combination that has been configured as "No", a fault code will be generated. In this situation, the ECM will ignore the multi-position switch until the keyswitch is cycled through OFF and ON.

Table 4

Range	Default
Programmed Low Idle to Programmed High Idle	0