Vibration Damper
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 323-4712 | Guide Bolt M24 by 500 mm |
2 |
- Remove the damper guard.
Show/hide table
Illustration 1 g02888505 - Remove two bolts (2) from vibration damper (1).
Show/hide table
Illustration 2 g02888851 - Install Tooling (A). Remove remaining bolts (2).
- Slide spacer (3) and vibration damper (1) on Tooling (A).
- Attach a suitable lifting device onto vibration damper (1). The weight of vibration damper (1) is approximately
148 kg (326 lb) . Slide spacer (3) and vibration damper (1) to the end of Tooling (A). Remove spacer (3) and vibration damper (1).
- Install vibration damper (1) in the reverse order of removal. Tighten bolts (1) to a torque of
700 ± 50 N·m (516 ± 37 lb ft) .
Caterpillar Information System:
C175-16 Marine Engine Fuel and Auxiliary Water Pump Drive
2012/06/08 Striped Wire Is Replaced With Improved Ink Jet Identification for Legacy (Parts Service) Wire harnesses {1408}
2012/02/20 New Torque Specification for Position Sensor on 3054E, C6.6, and C4.4 Engines {1408, 1907}
C7.1 (Mech) Industrial Engine Air Compressor - Remove and Install
2012/04/12 A New Service Replacement Front Housing Is Available for C175-16 Engines {1151, 1162, 1206}
C175-16 Marine Propulsion Engines Sensor Signal (Analog, Passive) - Test
C175-16 Marine Propulsion Engines Fuel Pressure Is High - Fuel Supply System
C175-16 and C175-20 Generator Set Engines Fuel Pressure Is Low - Fuel Supply System
C175-16 Engines for Off-Highway Truck/Tractors Fuel Pressure Is Low - Fuel Transfer System
C175-16 Marine Propulsion Engines Fuel Pressure Is High - Fuel Transfer System
C175-16 Marine Engine Engine Oil Screen
C7.1 (Mech) Industrial Engine Water Temperature Regulator - Remove and Install
3512B and 3512C Petroleum Generator Set Engines Cylinder Is Noisy
3516B Generator Set Engines with Dynamic Gas Blending ECM Does Not Communicate with Other Modules
CX48-P2300 Petroleum Transmission Control Manifold - Remove and Install
C175-16 Marine Engine Valve Mechanism Cover
3512B and 3512C Petroleum Generator Set Engines Engine Cranks but Does Not Start
C7 On-Highway Engine Fuel Manifold (ARD) - Disassemble
C7 On-Highway Engine Fuel Manifold (ARD) - Assemble
C175-16 Marine Engine Engine Oil Pan
CX48-P2300 Petroleum Transmission Transmission and Torque Converter - Separate
2013/04/10 A New Spark Plug Is Used in Certain G3500 and G3600 Engines {1550, 7519}
3512B and 3512C Petroleum Generator Set Engines Engine Does Not Crank
2012/05/09 A New Cylinder Block and Flywheel Housing Are Used for C175-16 Engines {1157, 1201}