Fuel and Auxiliary Water Pump Drive
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 138-7575 | Link Bracket | 1 |
B | 1P-0520 | Driver Gp | 1 |
Start By:
- Remove the fuel pump.
- Remove the auxiliary water pump.
- Attach Tooling (A) and a suitable lifting device onto housing (1). The weight of housing (1) is approximately
23 kg (50 lb) . Remove bolts (2). Remove housing (1).Show/hide tableIllustration 2 g01213648 - Remove O-ring seals (3) from housing (1).
Show/hide table
Illustration 3 g01213659 - Use Tooling (B) and a suitable press in order to remove bearing (4) from housing (1).
Show/hide table
Illustration 4 g02145875 - Remove fuel and auxiliary water pump drive gear (5).
Show/hide table
Illustration 5 g01215057 - Remove bolts (6). Remove adapter (7).
Show/hide table
Illustration 6 g01215060 - Remove O-ring seals (8) and (9).
Show/hide table
Illustration 7 g01215061 - Use Tooling (B) and a suitable press in order to remove bearing (10) from adapter (7).
Show/hide table
Illustration 1 | g02145874 |
- Install the fuel and auxiliary water pump drive in the reverse order of removal.
Caterpillar Information System:
2012/06/08 Striped Wire Is Replaced With Improved Ink Jet Identification for Legacy (Parts Service) Wire harnesses {1408}
2012/02/20 New Torque Specification for Position Sensor on 3054E, C6.6, and C4.4 Engines {1408, 1907}
C7.1 (Mech) Industrial Engine Air Compressor - Remove and Install
2012/04/12 A New Service Replacement Front Housing Is Available for C175-16 Engines {1151, 1162, 1206}
C175-16 Marine Propulsion Engines Sensor Signal (Analog, Passive) - Test
C175-16 Marine Propulsion Engines Fuel Pressure Is High - Fuel Supply System
C175-16 and C175-20 Generator Set Engines Fuel Pressure Is Low - Fuel Supply System
C175-16 Engines for Off-Highway Truck/Tractors Fuel Pressure Is Low - Fuel Transfer System
C175-16 Marine Propulsion Engines Fuel Pressure Is High - Fuel Transfer System
C175-16 Marine Engine Engine Oil Screen
C7.1 (Mech) Industrial Engine Water Temperature Regulator - Remove and Install
C7.1 (Mech) Industrial Engine Water Separator and Fuel Filter (Primary) - Remove and Install
C175-16 Marine Engine Vibration Damper
3512B and 3512C Petroleum Generator Set Engines Cylinder Is Noisy
3516B Generator Set Engines with Dynamic Gas Blending ECM Does Not Communicate with Other Modules
CX48-P2300 Petroleum Transmission Control Manifold - Remove and Install
C175-16 Marine Engine Valve Mechanism Cover
3512B and 3512C Petroleum Generator Set Engines Engine Cranks but Does Not Start
C7 On-Highway Engine Fuel Manifold (ARD) - Disassemble
C7 On-Highway Engine Fuel Manifold (ARD) - Assemble
C175-16 Marine Engine Engine Oil Pan
CX48-P2300 Petroleum Transmission Transmission and Torque Converter - Separate
2013/04/10 A New Spark Plug Is Used in Certain G3500 and G3600 Engines {1550, 7519}
3512B and 3512C Petroleum Generator Set Engines Engine Does Not Crank