C175-16 Marine Engine Caterpillar


Valve Mechanism Cover

Usage:

C175-16 M6B

Removal Procedure

Start By:

  1. Remove air cleaner.

  2. Remove exhaust shield.


    Illustration 1g02890776

  1. Remove five bolts (1) and remove valve cover (2).


    Illustration 2g02891037

  2. Remove seal (3) from valve cover (2).

  3. Repeat Steps 1 through 2 for the remaining valve covers.

Installation Procedure

  1. Install valve cover (2) in the reverse order of removal.

  2. Tighten bolts (1) to a torque of 28 ± 7 N·m (21 ± 5 lb ft).

Caterpillar Information System:

CX48-P2300 Petroleum Transmission Control Manifold - Remove and Install
3516B Generator Set Engines with Dynamic Gas Blending ECM Does Not Communicate with Other Modules
3512B and 3512C Petroleum Generator Set Engines Cylinder Is Noisy
C175-16 Marine Engine Vibration Damper
C175-16 Marine Engine Fuel and Auxiliary Water Pump Drive
2012/06/08 Striped Wire Is Replaced With Improved Ink Jet Identification for Legacy (Parts Service) Wire harnesses {1408}
2012/02/20 New Torque Specification for Position Sensor on 3054E, C6.6, and C4.4 Engines {1408, 1907}
C7.1 (Mech) Industrial Engine Air Compressor - Remove and Install
2012/04/12 A New Service Replacement Front Housing Is Available for C175-16 Engines {1151, 1162, 1206}
C175-16 Marine Propulsion Engines Sensor Signal (Analog, Passive) - Test
C175-16 Marine Propulsion Engines Fuel Pressure Is High - Fuel Supply System
C175-16 and C175-20 Generator Set Engines Fuel Pressure Is Low - Fuel Supply System
3512B and 3512C Petroleum Generator Set Engines Engine Cranks but Does Not Start
C7 On-Highway Engine Fuel Manifold (ARD) - Disassemble
C7 On-Highway Engine Fuel Manifold (ARD) - Assemble
C175-16 Marine Engine Engine Oil Pan
CX48-P2300 Petroleum Transmission Transmission and Torque Converter - Separate
2013/04/10 A New Spark Plug Is Used in Certain G3500 and G3600 Engines {1550, 7519}
3512B and 3512C Petroleum Generator Set Engines Engine Does Not Crank
2012/05/09 A New Cylinder Block and Flywheel Housing Are Used for C175-16 Engines {1157, 1201}
C175-16 Marine Propulsion Engines Sensor Signal (PWM) - Test
3512B and 3512C Petroleum Generator Set Engines Engine Has Early Wear
C175-16 Marine Propulsion Engines Sensor Supply - Test
3512B and 3512C Petroleum Generator Set Engines Engine Has Mechanical Noise (Knock)
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.