Transmission and Torque Converter - Separate
分离步骤
Show/hide table
所需工具     | |||
---|---|---|---|
工具     | 零件号     | 零件描述     | 数量     |
A     | 138-7574     | 连杆支架     | 4     |
B     | 308-3471     | 千斤顶台架总成     | 1     |
C     | -     | 1/2 - 13 x 2.5 in 顶出螺栓     | 2     |
D     | 1U-9200     | 杠杆式拉拔举倾机构总成     | 1     |
138-7573 | 连杆支架     | 2     | |
189-0410 | 钩环组件     | 1     |
- 将工具 (A) 和适当的起吊设备固定在变速箱和变矩器上。 变速箱和变矩器的重量约为 1633 kg (3600 lb)。
Show/hide table
图 1 | g02891776 |
- 断开线束组件 (1) 。
Show/hide table
图 2 | g02891798 |
- 拆下底部螺栓 (2) 。
Show/hide table
图 3 | g02891780 |
- 提升变速箱和变矩器。 重新放置垫块,以支撑变速箱,如图所示。
Show/hide table
图 4 | g02891842 |
- 拆下螺栓 (3) 和板 (4) 。
Show/hide table
图 5 | g02893419 |
- 拆下滤网组件 (5) 。
Show/hide table
图 6 | g02893441 |
- 拆下挡圈 (6) 和管组件 (7) 。
Show/hide table
图 7 | g02893538 |
- 拆下螺栓 (8) 、壳体 (9) 和管组件 (10) 。
Show/hide table
图 8 | g02893696 |
- 将工具 (A) 、工具 (D) 和适当的起吊设备装在变矩器 (11) 上。 变矩器 (11) 的重量约为 540 kg (1190 lb)。
Show/hide table
图 9 | g02893758 |
- 拆下其余的螺栓 (2) 。 使用工具 (C) 将变矩器与变速箱分离。
Caterpillar Information System:
C175-16 Marine Engine Engine Oil Pan
C7 On-Highway Engine Fuel Manifold (ARD) - Assemble
C7 On-Highway Engine Fuel Manifold (ARD) - Disassemble
3512B and 3512C Petroleum Generator Set Engines Engine Cranks but Does Not Start
C175-16 Marine Engine Valve Mechanism Cover
CX48-P2300 Petroleum Transmission Control Manifold - Remove and Install
3516B Generator Set Engines with Dynamic Gas Blending ECM Does Not Communicate with Other Modules
3512B and 3512C Petroleum Generator Set Engines Cylinder Is Noisy
C175-16 Marine Engine Vibration Damper
C175-16 Marine Engine Fuel and Auxiliary Water Pump Drive
2012/06/08 Striped Wire Is Replaced With Improved Ink Jet Identification for Legacy (Parts Service) Wire harnesses {1408}
2012/02/20 New Torque Specification for Position Sensor on 3054E, C6.6, and C4.4 Engines {1408, 1907}
2013/04/10 A New Spark Plug Is Used in Certain G3500 and G3600 Engines {1550, 7519}
3512B and 3512C Petroleum Generator Set Engines Engine Does Not Crank
2012/05/09 A New Cylinder Block and Flywheel Housing Are Used for C175-16 Engines {1157, 1201}
C175-16 Marine Propulsion Engines Sensor Signal (PWM) - Test
3512B and 3512C Petroleum Generator Set Engines Engine Has Early Wear
C175-16 Marine Propulsion Engines Sensor Supply - Test
3512B and 3512C Petroleum Generator Set Engines Engine Has Mechanical Noise (Knock)
CX48-P2300 Petroleum Transmission Pump Drive - Remove
CX48-P2300 Petroleum Transmission Gear Pump (Torque Converter and Transmission) - Remove and Install
CX48-P2300 Petroleum Transmission Transmission and Torque Converter - Connect
CX48-P2300 Petroleum Transmission Relief Valve (Torque Converter Inlet) - Remove and Install
CX48-P2300 Petroleum Transmission Gear Pump (Torque Converter and Transmission) - Disassemble