A New Service Replacement Front Housing Is Available for C175-16 Engines {1151, 1162, 1206}
- Generator Set:
- C175-16 (S/N: WYB1-UP)
- Engine:
- C175-16 (S/N: P6L1-UP)
Show/hide table
Illustration 1 | g02889937 |
(1) 384-0902 Housing As (2) Location of the 363-7294 Face Seal (3) Locations of the 310-7258 O-Ring Seal (4) Locations of the 5P-5599 O-Ring Seal in the idler gears |
The new housing assembly incorporates a face seal that is pressed in place. The face seal and the additional O-ring seals help to provide protection against leaks.
The new housing assembly and the seals are listed in Table 1.
Show/hide table
Item     | Qty     | Part     |
1     | 1     | 384-0902 Housing As     |
2     | 1     | 363-7294 Face Seal     |
3     | 2     | 310-7258 O-Ring Seal     |
4     | 4     | 5P-5599 O-Ring Seal     |
Note: When you install the front housing, install the four 5P-5599 O-Ring Seals around the bolts in the idler gears.
Caterpillar Information System:
C175-16 Marine Propulsion Engines Sensor Signal (Analog, Passive) - Test
C175-16 Marine Propulsion Engines Fuel Pressure Is High - Fuel Supply System
C175-16 and C175-20 Generator Set Engines Fuel Pressure Is Low - Fuel Supply System
C175-16 Engines for Off-Highway Truck/Tractors Fuel Pressure Is Low - Fuel Transfer System
C175-16 Marine Propulsion Engines Fuel Pressure Is High - Fuel Transfer System
C175-16 Marine Engine Engine Oil Screen
C7.1 (Mech) Industrial Engine Water Temperature Regulator - Remove and Install
C7.1 (Mech) Industrial Engine Water Separator and Fuel Filter (Primary) - Remove and Install
C7.1 (Mech) Industrial Engine Water Pump - Remove
C7.1 (Mech) Industrial Engine Water Pump - Install
C7.1 (Mech) Industrial Engine Vibration Damper and Pulley - Remove
C7.1 (Mech) Industrial Engine Vibration Damper and Pulley - Install
C7.1 (Mech) Industrial Engine Air Compressor - Remove and Install
2012/02/20 New Torque Specification for Position Sensor on 3054E, C6.6, and C4.4 Engines {1408, 1907}
2012/06/08 Striped Wire Is Replaced With Improved Ink Jet Identification for Legacy (Parts Service) Wire harnesses {1408}
C175-16 Marine Engine Fuel and Auxiliary Water Pump Drive
C175-16 Marine Engine Vibration Damper
3512B and 3512C Petroleum Generator Set Engines Cylinder Is Noisy
3516B Generator Set Engines with Dynamic Gas Blending ECM Does Not Communicate with Other Modules
CX48-P2300 Petroleum Transmission Control Manifold - Remove and Install
C175-16 Marine Engine Valve Mechanism Cover
3512B and 3512C Petroleum Generator Set Engines Engine Cranks but Does Not Start
C7 On-Highway Engine Fuel Manifold (ARD) - Disassemble
C7 On-Highway Engine Fuel Manifold (ARD) - Assemble