Component Location
Show/hide table
Illustration 1 | g01425221 |
Show/hide table
Illustration 2 | g01189857 |
Show/hide table
Illustration 3 | g01189902 |
Location Of The 3516C Engine Sensors
Show/hide table
Illustration 4 | g01145402 |
Typical left side view (1) Left turbocharger inlet pressure sensor (2) Exhaust temperature sensor (LH) (3) Connector for the CAN data link (4) Engine ECM (5) Engine speed/timing sensor (6) Unfiltered engine oil pressure sensor (7) Low oil level switch (8) Very low oil level switch (9) Filtered engine oil pressure sensor (10) Atmospheric pressure sensor (11) ECM connector J2/P2 (12) ECM connector J1/P1 |
Location Of The 3516C Engine Sensors
Show/hide table
Illustration 5 | g01145414 |
Typical right side view (13) Connector for the timing calibration sensor (14) Exhaust temperature sensor (RH) (15) Crankcase pressure sensor (16) Connector for the continuous oil renewal solenoid (17) Electric fuel priming pump (18) Coolant flow switch |
Location Of The 3516C Engine Sensors
Show/hide table
Illustration 6 | g01145410 |
Typical front and rear view (19) Connector for the engine fan speed sensor (20) Turbocharger outlet pressure sensor (21) Rear aftercooler temperature sensor |
Caterpillar Information System:
3608 Engine Engine Oil Pump - Disassemble
3516C Generator Set Engine System Overview
3608 Engine Valve Cover Base - Remove and Install
C12 Marine Engines Belts - Inspect/Adjust/Replace
14L Motor Grader Machine Systems Circle - Install
3608 Engine Engine Oil Filler and Oil Level Gauge - Remove and Install
3608 Engine Priority Valve - Install
3608 Engine Priority Valve - Assemble
3608 Engine Prelube Valve (Continuous) - Remove and Install
3608 Engine Prelubrication Oil Pump - Disassemble
2007/12/24 An Improved Exhaust Bellow is Used {1059}
3176C and 3196 Engines for Caterpillar Built Machines Engine Support (Front)
3608 Engine Engine Oil Pump - Assemble
3608 Engine Engine Oil Pump - Install
3608 Engine Water Pump - Assemble
3516B Engine for 994F and 994H Wheel Loaders Electrical Connectors
3516C Generator Set Engine Configuration Parameters
C15 and C18 Petroleum Engines Fuel Transfer Pump
3608 Engine Auxiliary Water Pump - Install
G3500 Generator Sets Battery or Battery Cable - Disconnect
3608 Engine Air Starting Motor - Disassemble
3608 Engine Air Starting Motor - Assemble
3608 Engine Air Starting Motor - Install
2007/11/05 Replacement of the Priming Pump {1258, 1263}