Auxiliary Water Pump - Install
Installation Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 138-7573     | Link Bracket     | 1     |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install a new seal for the joint between the auxiliary water pump and the front housing.
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
- Attach Tooling (A) and a suitable lifting device to auxiliary water pump (2). The weight of auxiliary water pump (2) is approximately 83 kg (182 lb).
Show/hide table
Illustration 1 | g01430451 |
(X) Sea Water Inlet (Y) Sea Water Outlet |
- Place auxiliary water pump (2) on the front housing. Ensure that the gear for the auxiliary water pump is properly meshed with the idler gear.
Note: Prior to installation of the auxiliary water pump, a visual inspection of the gear train must be completed. All gears in the front gear train must be inspected in order to ensure that any damage to gear teeth is repaired.
- Install bolts (1) that attach auxiliary water pump (2) to the front housing.
Note: Ensure that the auxiliary water pump is primed prior to start-up.
Caterpillar Information System:
C15 and C18 Petroleum Engines Fuel Transfer Pump
3516C Generator Set Engine Configuration Parameters
3516B Engine for 994F and 994H Wheel Loaders Electrical Connectors
3608 Engine Water Pump - Assemble
3608 Engine Engine Oil Pump - Install
3608 Engine Engine Oil Pump - Assemble
3500B Engines for Caterpillar Built Power Modules with the ADEM 3 Electronic Control Module Component Location
3608 Engine Engine Oil Pump - Disassemble
3516C Generator Set Engine System Overview
3608 Engine Valve Cover Base - Remove and Install
C12 Marine Engines Belts - Inspect/Adjust/Replace
14L Motor Grader Machine Systems Circle - Install
G3500 Generator Sets Battery or Battery Cable - Disconnect
3608 Engine Air Starting Motor - Disassemble
3608 Engine Air Starting Motor - Assemble
3608 Engine Air Starting Motor - Install
2007/11/05 Replacement of the Priming Pump {1258, 1263}
3608 Engine Barring Group - Remove and Install
Transmission, Torque Converter and Relief Valve Bench Test Procedures Reference Manual Contents {3030, 3101, 3133} Transmission, Torque Converter and Relief Valve Bench Test Procedures Reference Manual Contents {3030, 3101, 3133}
2008/04/14 A New Aftercooler is Now Used {1063}
Replace Exciter Rotor on LC6 Frame Generators{4457} Replace Exciter Rotor on LC6 Frame Generators{4457}
2007/10/22 Use Care During Disassembly of the Fuel Manifolds {1252, 1274}
2007/10/22 Use Care During Disassembly of the Fuel Manifolds {1252, 1274}
Troubleshooting the Fuel Priming and Primary Filter Pump Gp and the Fuel Filter Base Assembly {1256, 1258, 1260, 1261, 1263} Troubleshooting the Fuel Priming and Primary Filter Pump Gp and the Fuel Filter Base Assembly {1256, 1258, 1260, 1261, 1263}