3608 Engine Caterpillar

Barring Group - Remove and Install

Usage:

3608 1ZD

Removal Procedure

Show/hide table

NOTICE

Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life.

Show/hide table

Shut off the air supply at the air reservoir and drain the pressurized air from the air starting system. The sudden release of pressurized air can cause personal injury.

Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.

Show/hide table




Illustration 1	g00612961

Disconnect air hose (2) and air hose (3) from barring group (4) .

Remove bolts (1) that hold barring group (4) to the rear housing. Remove barring group (4) .

Installation Procedure

Show/hide table

NOTICE

Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life.

Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.

Show/hide table




Illustration 2	g00612961

Position barring group (4) on the engine block.

Note: During the installation of the barring group, the support assembly can be misaligned. Install bolts (1) hand tight. Operate the handle and the shaft in order to properly position the support assembly. Then tighten bolts (1) .

Install bolts (1) that hold barring group (4) to the rear housing.

Connect air hose (3) and air hose (2) to barring group (4) .

Caterpillar Information System:

2007/11/05 Replacement of the Priming Pump {1258, 1263}

3608 Engine Air Starting Motor - Install

3608 Engine Air Starting Motor - Assemble

3608 Engine Air Starting Motor - Disassemble

G3500 Generator Sets Battery or Battery Cable - Disconnect

3608 Engine Auxiliary Water Pump - Install

C15 and C18 Petroleum Engines Fuel Transfer Pump

3516C Generator Set Engine Configuration Parameters

3516B Engine for 994F and 994H Wheel Loaders Electrical Connectors

3608 Engine Water Pump - Assemble

3608 Engine Engine Oil Pump - Install

3608 Engine Engine Oil Pump - Assemble

Transmission, Torque Converter and Relief Valve Bench Test Procedures Reference Manual Contents {3030, 3101, 3133} Transmission, Torque Converter and Relief Valve Bench Test Procedures Reference Manual Contents {3030, 3101, 3133}

2008/04/14 A New Aftercooler is Now Used {1063}

Replace Exciter Rotor on LC6 Frame Generators{4457} Replace Exciter Rotor on LC6 Frame Generators{4457}

2007/10/22 Use Care During Disassembly of the Fuel Manifolds {1252, 1274}

2007/10/22 Use Care During Disassembly of the Fuel Manifolds {1252, 1274}

Troubleshooting the Fuel Priming and Primary Filter Pump Gp and the Fuel Filter Base Assembly {1256, 1258, 1260, 1261, 1263} Troubleshooting the Fuel Priming and Primary Filter Pump Gp and the Fuel Filter Base Assembly {1256, 1258, 1260, 1261, 1263}

3500B Engines for Caterpillar Built Power Modules with the ADEM 3 Electronic Control Module Ether Starting Aid - Test

C15 and C18 Petroleum Generator Sets Safety Messages

C18 Petroleum Generator Sets Safety Messages

C27 and C32 Industrial and Petroleum Engines Turbocharger

325D and 329D Excavators and 325D Material Handler Machine System Specifications Pilot Valve (Joystick)

C32 Marine Auxiliary Engine Refill Capacities and Recommendations