Air Starting Motor - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Attach a suitable lifting device to air starting motor (4). The weight of air starting motor (4) is approximately 54 kg (120 lb). Put air starting motor (4) in position on the rear housing. Install the bolts that hold air starting motor (4) in place.
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
Show/hide table
Illustration 1 | g00538622 |
- Connect hose assembly (2) and hose assembly (3) to the starter pinion nose housing.
- Connect tube assembly (1) to the air starting motor.
- Turn ON the air supply at the air reservoir.
Caterpillar Information System:
3608 Engine Air Starting Motor - Assemble
3608 Engine Air Starting Motor - Disassemble
G3500 Generator Sets Battery or Battery Cable - Disconnect
3608 Engine Auxiliary Water Pump - Install
C15 and C18 Petroleum Engines Fuel Transfer Pump
3516C Generator Set Engine Configuration Parameters
3516B Engine for 994F and 994H Wheel Loaders Electrical Connectors
3608 Engine Water Pump - Assemble
3608 Engine Engine Oil Pump - Install
3608 Engine Engine Oil Pump - Assemble
3500B Engines for Caterpillar Built Power Modules with the ADEM 3 Electronic Control Module Component Location
3608 Engine Engine Oil Pump - Disassemble
2007/11/05 Replacement of the Priming Pump {1258, 1263}
3608 Engine Barring Group - Remove and Install
Transmission, Torque Converter and Relief Valve Bench Test Procedures Reference Manual Contents {3030, 3101, 3133} Transmission, Torque Converter and Relief Valve Bench Test Procedures Reference Manual Contents {3030, 3101, 3133}
2008/04/14 A New Aftercooler is Now Used {1063}
Replace Exciter Rotor on LC6 Frame Generators{4457} Replace Exciter Rotor on LC6 Frame Generators{4457}
2007/10/22 Use Care During Disassembly of the Fuel Manifolds {1252, 1274}
2007/10/22 Use Care During Disassembly of the Fuel Manifolds {1252, 1274}
Troubleshooting the Fuel Priming and Primary Filter Pump Gp and the Fuel Filter Base Assembly {1256, 1258, 1260, 1261, 1263} Troubleshooting the Fuel Priming and Primary Filter Pump Gp and the Fuel Filter Base Assembly {1256, 1258, 1260, 1261, 1263}
3500B Engines for Caterpillar Built Power Modules with the ADEM 3 Electronic Control Module Ether Starting Aid - Test
C15 and C18 Petroleum Generator Sets Safety Messages
C18 Petroleum Generator Sets Safety Messages
C27 and C32 Industrial and Petroleum Engines Turbocharger