Belts - Inspect/Adjust/Replace
检查
检查交流发电机皮带和风扇传动皮带是否磨损和有裂纹。 如果皮带状况不佳,要更换皮带。
在两滑轮之间的中部施加110 N (25 lb) 的力,以检查皮带的张紧度。 调整正确的皮带将下垂13 至 19 mm (0.50 至 0.75 英寸)。
松皮带的滑动会降低被传动部件的效率。 松皮带的振动可能造成下列部件的不必要磨损:
- 皮带
- 皮带轮
- 轴承
如果皮带太紧,会对部件施加不必要的应力。 这可能缩短部件的使用寿命。
更换
对于需要多根传动皮带的应用,要更换相配的整组传动皮带。 只更换一组皮带中的一根传动皮带会因为旧皮带已拉长而引起新皮带承受更多的负载。 新传动皮带的额外负载会造成新传动皮带损坏。
交流发电机皮带调整
Show/hide table
图 1 | g00960176 |
(1) 调整螺母 (2) 安装螺栓 (3) 安装螺栓 (4) 安装螺栓 |
- 拆下传动皮带护罩。
- 拧松安装螺栓 (2) 、 (3) 和 (4) 。 拧松调整螺母 (1) 。
- 转动调整螺母 (1) 来增加或减小皮带张紧度。
- 拧紧调整螺母 (1) 。 拧紧安装螺栓 (2) 、 (3) 和 (4) 。
- 重新安装传动皮带护罩。
如果安装新皮带,应在发动机以额定转速运行 30 分钟后再次检查皮带张紧度。
Caterpillar Information System:
14L Motor Grader Machine Systems Circle - Install
3608 Engine Engine Oil Filler and Oil Level Gauge - Remove and Install
3608 Engine Priority Valve - Install
3608 Engine Priority Valve - Assemble
3608 Engine Prelube Valve (Continuous) - Remove and Install
3608 Engine Prelubrication Oil Pump - Disassemble
2007/12/24 An Improved Exhaust Bellow is Used {1059}
3176C and 3196 Engines for Caterpillar Built Machines Engine Support (Front)
14L Motor Grader Machine Systems Circle - Remove
C175-16 and C175-20 Generator Set Engines Cylinder Head
3608 Engine Turbocharger - Install
3608 Engine Turbocharger - Assemble
3608 Engine Valve Cover Base - Remove and Install
3516C Generator Set Engine System Overview
3608 Engine Engine Oil Pump - Disassemble
3500B Engines for Caterpillar Built Power Modules with the ADEM 3 Electronic Control Module Component Location
3608 Engine Engine Oil Pump - Assemble
3608 Engine Engine Oil Pump - Install
3608 Engine Water Pump - Assemble
3516B Engine for 994F and 994H Wheel Loaders Electrical Connectors
3516C Generator Set Engine Configuration Parameters
C15 and C18 Petroleum Engines Fuel Transfer Pump
3608 Engine Auxiliary Water Pump - Install
G3500 Generator Sets Battery or Battery Cable - Disconnect