Priority Valve - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install O-ring seals (7) around the sleeves in the front housing.
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
Show/hide table
Illustration 1 | g00555912 |
- Place priority valve (6) into position on the front housing. Install the bolts that hold the priority valve in place.
Show/hide table
Illustration 2 | g00555879 |
- Install tube (5) and elbow (4). Install the bolt that holds the bracket for tube (5) to the priority valve.
Show/hide table
Illustration 3 | g00555876 |
- Install elbow (2) onto tube (1). Ensure that the O-ring seals are in place.
- Connect tube assembly (3) to elbow (2). Close the drain valves on the engine oil filters.
- Ensure that the engine is filled with oil to the correct level. Refer to Operation and Maintenance Manual, "Engine Oil - Change".
Caterpillar Information System:
3608 Engine Priority Valve - Assemble
3608 Engine Prelube Valve (Continuous) - Remove and Install
3608 Engine Prelubrication Oil Pump - Disassemble
2007/12/24 An Improved Exhaust Bellow is Used {1059}
3176C and 3196 Engines for Caterpillar Built Machines Engine Support (Front)
14L Motor Grader Machine Systems Circle - Remove
C175-16 and C175-20 Generator Set Engines Cylinder Head
3608 Engine Turbocharger - Install
3608 Engine Turbocharger - Assemble
3608 Engine Turbocharger - Disassemble
3608 Engine Turbocharger - Remove
Procedure to Update a Standard TH48-E80 Oil/Gas Transmission to a Warm-Up Mode TH48-E80 Oil/Gas Transmission{1408, 3083, 3160, 3168, 4800, 7610} Procedure to Update a Standard TH48-E80 Oil/Gas Transmission to a Warm-Up Mode TH48-E80 Oil/Gas Transmission{1408, 3083, 3160, 3168, 4800, 7610}
3608 Engine Engine Oil Filler and Oil Level Gauge - Remove and Install
14L Motor Grader Machine Systems Circle - Install
C12 Marine Engines Belts - Inspect/Adjust/Replace
3608 Engine Valve Cover Base - Remove and Install
3516C Generator Set Engine System Overview
3608 Engine Engine Oil Pump - Disassemble
3500B Engines for Caterpillar Built Power Modules with the ADEM 3 Electronic Control Module Component Location
3608 Engine Engine Oil Pump - Assemble
3608 Engine Engine Oil Pump - Install
3608 Engine Water Pump - Assemble
3516B Engine for 994F and 994H Wheel Loaders Electrical Connectors
3516C Generator Set Engine Configuration Parameters