Priority Valve - Assemble
Assembly Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Clean all parts. Replace all parts that are damaged.
Note: Refer to Disassembly and Assembly, "General Information (Reference Material)" for more information.
- Apply clean engine oil to all parts of the valve before assembly.
Show/hide table
Illustration 1 | g00556060 |
Show/hide table
Improper assembly of parts that are spring loaded can cause bodily injury. To prevent possible injury, follow the established assembly procedure and wear protective equipment. |
- Install piston (6) in body (5). Install the piston with the shorter end of the piston toward the inside of the body. The piston must move freely inside the body.
- Install spring (7) and piston (2) in piston (6). Piston (2) must move freely in piston (6) .
- Install piston (8) and spring (9) in body (5) .
- Install O-ring seal (1) in body (5) .
Note: Ensure that spring (9) fits into the counterbore in cover (3) when the cover is installed.
- Place cover (3) in position on body (5). Install bolts (4) .
End By: Install the priority valve. Refer to Disassembly and Assembly, "Priority Valve - Install".
Caterpillar Information System:
3608 Engine Prelube Valve (Continuous) - Remove and Install
3608 Engine Prelubrication Oil Pump - Disassemble
2007/12/24 An Improved Exhaust Bellow is Used {1059}
3176C and 3196 Engines for Caterpillar Built Machines Engine Support (Front)
14L Motor Grader Machine Systems Circle - Remove
C175-16 and C175-20 Generator Set Engines Cylinder Head
3608 Engine Turbocharger - Install
3608 Engine Turbocharger - Assemble
3608 Engine Turbocharger - Disassemble
3608 Engine Turbocharger - Remove
Procedure to Update a Standard TH48-E80 Oil/Gas Transmission to a Warm-Up Mode TH48-E80 Oil/Gas Transmission{1408, 3083, 3160, 3168, 4800, 7610} Procedure to Update a Standard TH48-E80 Oil/Gas Transmission to a Warm-Up Mode TH48-E80 Oil/Gas Transmission{1408, 3083, 3160, 3168, 4800, 7610}
3608 Engine Exhaust Manifold - Remove and Install
3608 Engine Priority Valve - Install
3608 Engine Engine Oil Filler and Oil Level Gauge - Remove and Install
14L Motor Grader Machine Systems Circle - Install
C12 Marine Engines Belts - Inspect/Adjust/Replace
3608 Engine Valve Cover Base - Remove and Install
3516C Generator Set Engine System Overview
3608 Engine Engine Oil Pump - Disassemble
3500B Engines for Caterpillar Built Power Modules with the ADEM 3 Electronic Control Module Component Location
3608 Engine Engine Oil Pump - Assemble
3608 Engine Engine Oil Pump - Install
3608 Engine Water Pump - Assemble
3516B Engine for 994F and 994H Wheel Loaders Electrical Connectors