Engine Oil Filter Base - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Check the O-ring seals, the gaskets, and the seals for wear or for damage. Replace the components, if necessary.
- Position engine oil filter base (6) and install bolts (5) .
Show/hide table
Illustration 1 | g01377180 |
- Connect tube assembly (4) .
- Install bolt (3) .
- Connect hose assembly (2) .
- Connect hose assembly (1) .
- Install new engine oil filter (7) .
- Change the engine oil. Refer to Operation and Maintenance Manual, "Engine Oil and Filter - Change".
End By: Install the clean gas induction cooler. Refer to Disassembly and Assembly, "Clean Gas Induction Cooler - Remove and Install".
Caterpillar Information System:
C15 On-Highway Engine Engine Oil Filter Base - Remove
C175-16 and C175-20 Generator Set Engines Finding the Top Center Position for the No. 1 Piston
C15 On-Highway Engine Water Temperature Regulator Housing - Remove and Install
3512C Petroleum Engines Analog Sensor (Passive)
C15 On-Highway Engine Water Pump - Install
C15 On-Highway Engine Water Pump - Remove
2006/08/07 A New Kit for the Cooling System Pressure Cap is Available {1353, 1354, 1382, 1392, 7405}
3508B, 3512B, and 3516B High Displacement Generator Sets Overhaul (Top End)
3508B, 3512B, and 3516B High Displacement Generator Sets Overhaul (Major)
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Control Manifold - Install
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Control Manifold - Remove
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Relief Valve (Transmission Lubrication) - Assemble
G3500 Engines Flywheel
C175-16 Locomotive Engine Valve Lash - Adjust
3500B Generator Sets Emergency Stopping
C15 On-Highway Engine Valve Mechanism Cover - Remove and Install
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Transfer Gears - Remove - Idler
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Transfer Gears - Install - Idler
2006/07/01 A New Backup Ring for the Fuel Injector Group is Now Available {1251, 1254, 1290}
C11 and C13 Engines Valve Mechanism Cover - Remove and Install
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Modulating Valve (Transmission Clutch) - Remove and Install
C27 and C32 Generator Set Engines Fan Drive - Remove and Install
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Torque Converter - Remove
TH48-E70 Oil/Gas Transmission and TH48-E70-C27 and TH48-E70-C32 Package Torque Converter - Install