Engine Oil Cooler - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Inspect the condition of gaskets (2). Replace gaskets (2), if necessary. Install gaskets (2) on engine oil cooler (1) .
Show/hide table
Illustration 1 | g01028619 |
- Install engine oil cooler (1) in the cylinder block.
End By: Install the engine oil filter base. Refer to Disassembly and Assembly, "Engine Oil Filter Base - Install".
Caterpillar Information System:
C7 On-highway Engine Engine Oil Cooler - Remove
C7 On-highway Engine Fuel Filter Base - Remove and Install
C7 On-highway Engine Fuel Priming Pump - Remove and Install
C9 Marine Engines and C9 Marine Generator Sets Flywheel - Install
C9 Marine Engines and C9 Marine Generator Sets Flywheel - Remove
2003/10/01 New Fuel Lines Help to Eliminate Damage from Rubbing {1274}
3126B Industrial Engine Air Compressor - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines E361 High Engine Coolant Temperature
C11 and C13 Engines for Caterpillar Built Machines E539 High Intake Manifold Air Temperature
C11 and C13 Engines for Caterpillar Built Machines E360 Low Engine Oil Pressure
2003/10/01 Improved Water Pump Seal {1361}
C11, C13 and C15 On-highway Engines Selected Engine Rating
G3500H 60Hz Generator Sets Water Pump - Inspect
C7 PETROLEUM Petroleum Engine Crankshaft Front Seal - Remove
C7 PETROLEUM Petroleum Engine Crankshaft Front Seal - Install
EMCP3 General Information
2003/10/01 A New Cylinder Head Group For G3408 Engines {1100}
2003/12/01 Improved Auxiliary Drive Coupling {3279}
C9 Marine Engines and C9 Marine Generator Sets Water Pump - Disassemble
C9 Marine Engines and C9 Marine Generator Sets Water Pump - Assemble
3516B HD Generator Set Generator Set - Test
C9 Marine Engines and C9 Marine Generator Sets Engine Oil Filter Base - Remove
C9 Marine Engines and C9 Marine Generator Sets Engine Oil Filter Base - Install
C32 Petroleum Generator Sets Burn Prevention