Flywheel - Remove
Show/hide table
Required Tools | |||
---|---|---|---|
Tool | Part Number | Part Description | Qty |
A | 138-7573 | Link Bracket | 1 |
B | - | Guide Stud (M16 x 2 x 110 mm) |
1 |
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Fasten Tooling (A) and a suitable lifting device to flywheel (2). The weight of flywheel (2) is approximately
48 kg (105 lb) . - Remove top bolt (1) and discard. Install Tooling (B). Remove remaining bolts (1) and discard. Remove flywheel (2) from the crankshaft.
Show/hide table
Illustration 2 g01028586 - Inspect flywheel ring gear (3). Replace the flywheel ring gear, if necessary. Place flywheel (2) on a wood block. Use a hammer and a punch to remove the flywheel ring gear.
Show/hide table
Illustration 1 | g01028561 |
Caterpillar Information System:
2003/10/01 New Fuel Lines Help to Eliminate Damage from Rubbing {1274}
3126B Industrial Engine Air Compressor - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines E361 High Engine Coolant Temperature
C11 and C13 Engines for Caterpillar Built Machines E539 High Intake Manifold Air Temperature
C11 and C13 Engines for Caterpillar Built Machines E360 Low Engine Oil Pressure
2003/10/01 Improved Water Pump Seal {1361}
C11, C13 and C15 On-highway Engines Selected Engine Rating
C13 and C15 On-highway Engines Multi-Torque - Test
C11, C13 and C15 On-highway Engines Output Selections
C7 and C9 On-Highway Engines Two Speed Axle Switch Circuit - Test
2003/10/01 Correct Lash Setting for the Fuel Injector {1290}
C9 Marine Engines and C9 Marine Generator Sets Housing (Front) - Install
C9 Marine Engines and C9 Marine Generator Sets Flywheel - Install
C7 On-highway Engine Fuel Priming Pump - Remove and Install
C7 On-highway Engine Fuel Filter Base - Remove and Install
C7 On-highway Engine Engine Oil Cooler - Remove
C7 On-highway Engine Engine Oil Cooler - Install
G3500H 60Hz Generator Sets Water Pump - Inspect
C7 PETROLEUM Petroleum Engine Crankshaft Front Seal - Remove
C7 PETROLEUM Petroleum Engine Crankshaft Front Seal - Install
EMCP3 General Information
2003/10/01 A New Cylinder Head Group For G3408 Engines {1100}
2003/12/01 Improved Auxiliary Drive Coupling {3279}
C9 Marine Engines and C9 Marine Generator Sets Water Pump - Disassemble