Water Pump - Disassemble
Show/hide table
Required Tools | |||
Tool | Part Number | Part Description | Qty |
A | 1P-0510 | Driver Group | 1 |
B | 1U-6400 | Three Jaw Puller | 1 |
Start By:
- Remove the water pump. Refer to Disassembly and Assembly, "Water Pump - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Use Tooling (B) to remove pulley (3) from the shaft assembly.
- Remove bolts and washers (2). Remove cover (1). Remove gasket (4) from cover (1) and housing (5). Thoroughly clean the cover and the housing.
Show/hide table
Illustration 2 g01029260 - Position housing (5) on the press. Use spacer plates to level the housing.
- Push shaft assembly (7) out of impeller (6) with a suitable drive plate from Tooling (A) and a press. Remove impeller (6).
Show/hide table
Illustration 3 g01029262 - Continue to push shaft assembly (7) out of seal assembly (8) and housing (5).
Note: Do not allow the shaft assembly to fall to the floor when the shaft assembly is removed.
Show/hide tableIllustration 4 g01029400 - Remove seal assembly (8) from housing (5) with Tooling (A) and a press.
Show/hide table
Illustration 1 | g01029251 |
Caterpillar Information System:
2003/12/01 Improved Auxiliary Drive Coupling {3279}
2003/10/01 A New Cylinder Head Group For G3408 Engines {1100}
EMCP3 General Information
C7 PETROLEUM Petroleum Engine Crankshaft Front Seal - Install
C7 PETROLEUM Petroleum Engine Crankshaft Front Seal - Remove
G3500H 60Hz Generator Sets Water Pump - Inspect
C7 On-highway Engine Engine Oil Cooler - Install
C7 On-highway Engine Engine Oil Cooler - Remove
C7 On-highway Engine Fuel Filter Base - Remove and Install
C7 On-highway Engine Fuel Priming Pump - Remove and Install
C9 Marine Engines and C9 Marine Generator Sets Flywheel - Install
C9 Marine Engines and C9 Marine Generator Sets Flywheel - Remove
C9 Marine Engines and C9 Marine Generator Sets Water Pump - Assemble
3516B HD Generator Set Generator Set - Test
C9 Marine Engines and C9 Marine Generator Sets Engine Oil Filter Base - Remove
C9 Marine Engines and C9 Marine Generator Sets Engine Oil Filter Base - Install
C32 Petroleum Generator Sets Burn Prevention
3412C Generator Set Cooling System Coolant Sample (Level 2) - Obtain
C9 Marine Engines and C9 Marine Generator Sets Front Cover - Remove
C9 Marine Engines and C9 Marine Generator Sets Front Cover - Install
C9 Marine Engines and C9 Marine Generator Sets Valve Mechanism Cover - Remove and Install
3508, 3512, and 3516 Generator Sets Cooling System Coolant Sample (Level 1) - Obtain
3508, 3512, and 3516 Generator Sets Cooling System Coolant Sample (Level 2) - Obtain
2003/11/01 New Oil Pan and Integral Seal {1302, 1302, 1302}