Housing (Front) - Remove
拆卸步骤
开始:
- 拆卸空气压缩机。 请参考解体及组装, "空气压缩机 - 拆卸和安装"。
- 拆卸发动机机油泵。 请参考解体及组装, "发动机机油泵 - 拆卸"。
- 拆卸水泵。 请参考解体及组装, "水泵 - 拆卸"。
- 拆卸凸轮轴。 请参考解体及组装, "凸轮轴 - 拆卸"。
- 拆卸前齿轮组。 请参考解体及组装, "齿轮总成 (前) - 拆卸"。
- 拆卸曲轴传感器。 请参考解体及组装, "发动机传感器 - 拆卸和安装"。
- 断开传感器 (1) 。
Show/hide table
图 1 | g01011130 |
- 将适当的提升设备连接到发动机前面的提升支架。 发动机的重量约为 680 kg (1500 lb)。
- 拆卸前发动机支架 (4) 。
- 拧松油底壳螺栓以使油底壳前部下降。
- 拆卸螺栓 (2) 。
- 拆卸前壳体 (3) 。
Caterpillar Information System:
C15 and C18 Petroleum Generator Sets Standby Generator Set Maintenance Recommendations
Cat® Digital Voltage Regulator General Information
C11 and C13 Engines Camshaft - Remove
C11 and C13 Engines Engine Sensors - Remove and Install
3406C Marine Auxiliary Generator Set Reference Material
C13 Engine Turbocharger - Install - Low Pressure Turbocharger
C13 Engine Turbocharger - Remove - Low Pressure Turbocharger
C32 Auxiliary Engine Battery Charger - Check
2003/09/01 The Oil Pan Gasket now Requires a Gasket Sealant to be Used {1302, 7555}
C11 and C13 Engines Flywheel Housing - Remove and Install
C13 Engine Flywheel - Install
C13 Engine Flywheel - Remove
C13 Engine Housing (Front) - Install
C11 and C13 Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Accessory Drive - Remove
C11 and C13 Engines for Caterpillar Built Machines Accessory Drive - Install
3406C Marine Auxiliary Generator Set Engine Air Cleaner Element - Clean/Replace
C11 and C13 Engines Camshaft - Install
C9 On-highway Engines Engine Oil Level Gauge - Calibrate
2003/07/01 Replacement of the Piston Cooling Jet {1331}
C9 On-highway Engines Engine Oil and Filter - Change
C11 and C13 Engines for Caterpillar Built Machines Cylinder Liner - Remove
C11 and C13 Engines for Caterpillar Built Machines Crankshaft Gear - Remove and Install