Flywheel - Remove
拆卸步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件名称     | 数量     |
A     | 138-7573     | 连接支架     | 2     |
B     | FT2712     | 导向螺柱     | 2     |
- 将工具 (A) 安装到飞轮 (2) 上。 将适当提升设备固定到飞轮 (2) 上。 飞轮的重量约为 41 kg (90 lb)。
Show/hide table
图 1 | g01010803 |
- 拆卸和第一个螺栓相差 180 度的两个螺栓 (1) 。 安装工具 (B) 。
- 拆卸剩余的 6 个螺栓 (1) 。
- 拆卸飞轮 (2) 。
- 检查飞轮齿轮。 如有必要,更换齿圈。 把飞轮放在木板上。 使用锤子和冲头来拆卸齿圈。
Caterpillar Information System:
C11 and C13 Engines Water Temperature Regulator - Remove and Install
C11 and C13 Engines Diverter Valve (Oil) - Install
C11 and C13 Engines Diverter Valve (Oil) - Remove
C13 Engine Engine Control Module - Remove and Install
C11 and C13 Engines Air Compressor - Remove and Install
C13 Engine Exhaust Manifold - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Engine Oil Pump - Assemble
C11 and C13 Engines for Caterpillar Built Machines Engine Oil Pump - Disassemble
C11 and C13 Engines for Caterpillar Built Machines Engine Oil Pump - Install
C11 and C13 Engines for Caterpillar Built Machines Engine Oil Pump - Remove
C11 and C13 Engines for Caterpillar Built Machines Engine Oil Filter Base - Assemble
C11 and C13 Engines for Caterpillar Built Machines Engine Oil Filter Base - Disassemble
C13 Engine Flywheel - Install
C11 and C13 Engines Flywheel Housing - Remove and Install
2003/09/01 The Oil Pan Gasket now Requires a Gasket Sealant to be Used {1302, 7555}
C32 Auxiliary Engine Battery Charger - Check
C13 Engine Turbocharger - Remove - Low Pressure Turbocharger
C13 Engine Turbocharger - Install - Low Pressure Turbocharger
3406C Marine Auxiliary Generator Set Reference Material
C11 and C13 Engines Engine Sensors - Remove and Install
C11 and C13 Engines Camshaft - Remove
Cat® Digital Voltage Regulator General Information
C15 and C18 Petroleum Generator Sets Standby Generator Set Maintenance Recommendations
C13 Engine Housing (Front) - Remove