General Information
Show/hide table
Illustration 1 | g01425354 |
Show/hide table
The Cat Digital Voltage Regulator presents an electrical shock/electrocution hazard. This hazard will cause serious injury or death. Service by trained personnel only. The terminals and heat sinks are live at hazardous voltages when power is applied and for up to 8 minutes after power is removed. |
The only preventive maintenance that is required on the voltage regulator is to check periodically the connections between the voltage regulator and the system. The connections must be clean and tight. Voltage regulator units are manufactured using state-of-the-art, surface-mount technology. Caterpillar recommends that no repair procedures be attempted by anyone other than Caterpillar dealer technicians.
Caterpillar Information System:
C11 and C13 Engines Camshaft - Remove
C11 and C13 Engines Engine Sensors - Remove and Install
3406C Marine Auxiliary Generator Set Reference Material
C13 Engine Turbocharger - Install - Low Pressure Turbocharger
C13 Engine Turbocharger - Remove - Low Pressure Turbocharger
C32 Auxiliary Engine Battery Charger - Check
2003/09/01 The Oil Pan Gasket now Requires a Gasket Sealant to be Used {1302, 7555}
C11 and C13 Engines Flywheel Housing - Remove and Install
C13 Engine Flywheel - Install
C13 Engine Flywheel - Remove
C11 and C13 Engines Water Temperature Regulator - Remove and Install
C11 and C13 Engines Diverter Valve (Oil) - Install
C15 and C18 Petroleum Generator Sets Standby Generator Set Maintenance Recommendations
C13 Engine Housing (Front) - Remove
C13 Engine Housing (Front) - Install
C11 and C13 Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Accessory Drive - Remove
C11 and C13 Engines for Caterpillar Built Machines Accessory Drive - Install
3406C Marine Auxiliary Generator Set Engine Air Cleaner Element - Clean/Replace
C11 and C13 Engines Camshaft - Install
C9 On-highway Engines Engine Oil Level Gauge - Calibrate
2003/07/01 Replacement of the Piston Cooling Jet {1331}
C9 On-highway Engines Engine Oil and Filter - Change