Turbocharger - Remove - Low Pressure Turbocharger
拆卸步骤
- 在波纹管上标上标记,用于在安装过程中对准和定位。
Show/hide table
图 1 | g01010976 |
- 松开卡箍 (4) 。
Show/hide table
注意 |
---|
不遵守下列规定程序可能导致零件损坏。 为了避免损坏零件,总是确认和标记零件,以便零件可以安装在相同的位置。 |
Show/hide table
波纹管的末端很锋利。 如果波纹管处理不妥当,可能会发生伤害。 通过波纹部位拿住波纹管。 |
注: 有关更多处理波纹管的信息,请参考专门说明书, REHS1728, "波纹管应用指南"。
- 将卡箍 (4) 放置在波纹管 (5) 上。
- 松开卡箍 (11) 。
- 松开卡箍 (6) 。
- 将卡箍 (6) 放置在波纹管 (7) 上。
- 拆卸弯管 (14) 、弯管 (8) 和弯管 (3) 。
- 断开弯管 (1) 。
- 拆卸卡箍 (9) 。
- 断开供油管组件 (2) 和排油管组件 (10) 。
- 拆卸螺母 (12) 。
- 使用适当的提升装置。 涡轮增压器的重量约为 29 kg (65 lb)。 拆卸涡轮增压器 (13) 。
Caterpillar Information System:
C32 Auxiliary Engine Battery Charger - Check
2003/09/01 The Oil Pan Gasket now Requires a Gasket Sealant to be Used {1302, 7555}
C11 and C13 Engines Flywheel Housing - Remove and Install
C13 Engine Flywheel - Install
C13 Engine Flywheel - Remove
C11 and C13 Engines Water Temperature Regulator - Remove and Install
C11 and C13 Engines Diverter Valve (Oil) - Install
C11 and C13 Engines Diverter Valve (Oil) - Remove
C13 Engine Engine Control Module - Remove and Install
C11 and C13 Engines Air Compressor - Remove and Install
C13 Engine Exhaust Manifold - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Engine Oil Pump - Assemble
C13 Engine Turbocharger - Install - Low Pressure Turbocharger
3406C Marine Auxiliary Generator Set Reference Material
C11 and C13 Engines Engine Sensors - Remove and Install
C11 and C13 Engines Camshaft - Remove
Cat® Digital Voltage Regulator General Information
C15 and C18 Petroleum Generator Sets Standby Generator Set Maintenance Recommendations
C13 Engine Housing (Front) - Remove
C13 Engine Housing (Front) - Install
C11 and C13 Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
C11 and C13 Engines for Caterpillar Built Machines Accessory Drive - Remove
C11 and C13 Engines for Caterpillar Built Machines Accessory Drive - Install