Water Pump - Install
- Put a new gasket for the water pump elbow in place. Install water pump (1). Install the bolts and the washers that hold the water pump and the elbow in place.
Show/hide table
Illustration 2 g00991865 - Put a thin layer of engine oil on seal (3).
- Put a new gasket between the exhaust manifold and tube assembly (2) in position. Install tube assembly (2) and the bolts that hold the tube assembly in place.
- Tighten the hose clamp on the hose to the oil cooler.
Show/hide table
Illustration 3 g00991870 - Install clip (4) with the bolt and the washer. Clip (4) holds the breather tube in place.
- Connect the hose from the radiator to the water pump.
- Fill the cooling system with coolant to the correct level. Refer to the Operation and Maintenance Manual for the correct filling procedure.
Show/hide table
Illustration 1 | g00991864 |
Caterpillar Information System:
3054E Industrial Engine Flywheel - Install
G3304 and G3306 Engines Water Pump - Remove
C1.5 and C2.2 Generator Lead Connections
3044C Industrial Engine Gauges and Indicators
CIPI UNDERCARRIAGE Arrangements: 1667049, 2372904, 3Q6481, 6Z7988, 6Z7989, 9Q5032, 9Q5040, 9Q5043, 9Q5046, 9Q5047, 9Q5066, 9Q5074, 9Q5097, 9Q5098, 9Q5116, 9Q5134, 9Q5136, 9Q5142, 9Q5147, 9Q5148, 9Q5149, 9Q5172 and 9Q5204 Maintenance Interval Schedule
3500B Engines Air Inlet and Exhaust Lines
3500B Engines for 776D, 777D, 784C, 785C, 789C and 793C Off-Highway Trucks MID 036 - CID 1495 - FMI 02 Injector Trim Codes Not Programmed
G3304 and G3306 Engines Carburetor - Remove
G3304 and G3306 Engines Carburetor - Install
C7 On-highway Engine Water Pump - Remove
G3304 and G3306 Engines Valve Lifter - Install
C1.5 and C2.2 Generator Generator - Install
G3304 and G3306 Engines Water Pump - Disassemble
Installation Guide for Industrial Electronic Engine Displays General Information
3618 Engine Engine Mounts - Inspect
Rotating Group Adjustment Instructions for Bosch Rexroth Hydraulic Pumps and Motors {3203, 4351, 5058, 5070} Rotating Group Adjustment Instructions for Bosch Rexroth Hydraulic Pumps and Motors {3203, 4351, 5058, 5070}
3044C Industrial Engine Fuel System - Prime
Installation Guide for Industrial Electronic Engine Displays Wiring - General
C7 On-highway Engine Water Pump - Install
3044C Industrial Engine Fuel System Filter - Replace
C1.5 and C2.2 Generator Leads - Connect
3044C Industrial Engine Fuel System Primary Filter/Water Separator - Drain
C7 On-Highway Engine Air Compressor - Remove and Install
330B Excavator Hydraulic System Accumulator (Pilot) - Test and Charge