Water Pump - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Clean the mating surfaces of the water pump and the cylinder block.
- Ensure that the O-ring seals are installed on the water pump.
- Position water pump (4) on the front of the engine. Install bolts (3) .
Show/hide table
Illustration 1 | g00991992 |
- Connect the hose assemblies to the top of the water pump.
- Install the inlet hose to the water pump. Install the hose clamps.
- Install the outlet hose to the water pump. Install the hose clamps.
- Position support bracket (2). Install bolts (1) .
- Fill the cooling system with coolant to the correct level. Refer to the Operation and Maintenance Manual for the correct filling procedure.
End By: Install the alternator. Refer to Disassembly and Assembly, "Alternator - Remove and Install".
Caterpillar Information System:
Installation Guide for Industrial Electronic Engine Displays Wiring - General
3044C Industrial Engine Fuel System - Prime
Rotating Group Adjustment Instructions for Bosch Rexroth Hydraulic Pumps and Motors {3203, 4351, 5058, 5070} Rotating Group Adjustment Instructions for Bosch Rexroth Hydraulic Pumps and Motors {3203, 4351, 5058, 5070}
3618 Engine Engine Mounts - Inspect
Installation Guide for Industrial Electronic Engine Displays General Information
G3304 and G3306 Engines Water Pump - Disassemble
G3304 and G3306 Engines Water Pump - Install
3054E Industrial Engine Flywheel - Install
G3304 and G3306 Engines Water Pump - Remove
C1.5 and C2.2 Generator Lead Connections
3044C Industrial Engine Gauges and Indicators
CIPI UNDERCARRIAGE Arrangements: 1667049, 2372904, 3Q6481, 6Z7988, 6Z7989, 9Q5032, 9Q5040, 9Q5043, 9Q5046, 9Q5047, 9Q5066, 9Q5074, 9Q5097, 9Q5098, 9Q5116, 9Q5134, 9Q5136, 9Q5142, 9Q5147, 9Q5148, 9Q5149, 9Q5172 and 9Q5204 Maintenance Interval Schedule
3044C Industrial Engine Fuel System Filter - Replace
C1.5 and C2.2 Generator Leads - Connect
3044C Industrial Engine Fuel System Primary Filter/Water Separator - Drain
C7 On-Highway Engine Air Compressor - Remove and Install
330B Excavator Hydraulic System Accumulator (Pilot) - Test and Charge
C7 On-highway Engine Water Pump - Disassemble
C7 On-highway Engine Water Pump - Assemble
C1.5 and C2.2 Generator Rotating Rectifier - Test
Installation Guide for Industrial Electronic Engine Displays Wiring - CAT Data Link (CDL)
3500B and 3500C Marine Propulsion Engines Engine Sensor Open/Short Test
2003/09/01 New Slave Piston Lash Settings are Available for Heavy-Duty Diesel Engines {1119, 1129}
Cold Weather Recommendations for On-Highway Diesel Truck Engines Cold Weather Recommendation Charts