Water Pump - Disassemble
Disassembly Procedure
Show/hide table
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 1P-0510     | Driver Group     | 1     |
Start By:
- Remove the water pump. Refer to Disassembly and Assembly, "Water Pump - Remove".
- Remove bolts (1). Remove pulley (2) .
Show/hide table
Illustration 1 | g00992177 |
- Remove O-ring seals (4) from cover (3) of the water pump. Remove bolts (5) and the washers. Remove the cover and the gasket from the water pump.
Show/hide table
Illustration 2 | g00992333 |
- Position the water pump in a press. Use spacer plates to level the water pump.
Show/hide table
Illustration 3 | g00992182 |
- Use Tooling (A) and a press to remove shaft assembly (7) out of impeller (6). Remove the impeller.
- Continue to push shaft assembly (7) out of water pump seal assembly (8) and the water pump housing.
Show/hide table
Illustration 4 | g00992183 |
Note: Do not allow the shaft assembly and the hub to fall to the floor when the shaft assembly is removed from the water pump housing.
- If necessary, use Tooling (A) and press shaft assembly (7) out of hub (9) .
- Reposition the water pump housing in order to remove the water pump seal assembly from the water pump housing.
Show/hide table
Illustration 5 | g00988210 |
Caterpillar Information System:
330B Excavator Hydraulic System Accumulator (Pilot) - Test and Charge
C7 On-Highway Engine Air Compressor - Remove and Install
3044C Industrial Engine Fuel System Primary Filter/Water Separator - Drain
C1.5 and C2.2 Generator Leads - Connect
3044C Industrial Engine Fuel System Filter - Replace
C7 On-highway Engine Water Pump - Install
Installation Guide for Industrial Electronic Engine Displays Wiring - General
3044C Industrial Engine Fuel System - Prime
Rotating Group Adjustment Instructions for Bosch Rexroth Hydraulic Pumps and Motors {3203, 4351, 5058, 5070} Rotating Group Adjustment Instructions for Bosch Rexroth Hydraulic Pumps and Motors {3203, 4351, 5058, 5070}
3618 Engine Engine Mounts - Inspect
Installation Guide for Industrial Electronic Engine Displays General Information
G3304 and G3306 Engines Water Pump - Disassemble
C7 On-highway Engine Water Pump - Assemble
C1.5 and C2.2 Generator Rotating Rectifier - Test
Installation Guide for Industrial Electronic Engine Displays Wiring - CAT Data Link (CDL)
3500B and 3500C Marine Propulsion Engines Engine Sensor Open/Short Test
2003/09/01 New Slave Piston Lash Settings are Available for Heavy-Duty Diesel Engines {1119, 1129}
Cold Weather Recommendations for On-Highway Diesel Truck Engines Cold Weather Recommendation Charts
Installation Guide for Industrial Electronic Engine Displays Wiring - J1939 Data Link
3406E, C-10 and C-12 On-highway Engines Replacing the ECM
G3304 and G3306 Engines Water Pump - Assemble
3500B Engines Engine Oil Lines - Front Mounted Engine Oil Filter
Installation Guide for Industrial Electronic Engine Displays Engine Monitoring System
G3304 and G3306 Engines Water Temperature Regulator - Remove