ECM Will Not Communicate with Other Systems or Display Modules
Note: If the vessel is equipped with a Multi-Station Control System (MSCS), refer to Service Manual, RENR7651, "Marine Multi-Station Control System" for the proper troubleshooting procedure.
- Wiring and/or electrical connectors
- Cat Data Link
- CAN data link (if equipped)
- Electronic Control Module (ECM)
- Connect the electronic service tool to the service tool connector. If the ECM does not communicate with the electronic service tool, refer to Troubleshooting, "Electronic Service Tool Will Not Communicate with ECM".
- Troubleshoot the Cat Data Link for possible problems. Refer to Troubleshooting, "Cat Data Link Circuit - Test".
- Troubleshoot the CAN data link (if equipped) for possible problems. Refer to Troubleshooting, "CAN Data Link Circuit - Test".
Caterpillar Information System:
120H and 135H Motor Graders Hydraulic and Steering System Control Valve (Snow Plow/Dozer Angle)
2001/08/01 A New Piston and Piston Rings Are Now Available {1214, 1215}
HDB Series and M1 Series Heavy Duty Brushless Alternators Residual Magnetism - Restore
3412E, C30 and C32 Marine Engines Engine Oil Filter Base - Assemble
2001/08/01 Additional Troubleshooting Procedures For Speed Burps {1901, 1913}
2001/08/01 Oil Pan No Longer Requires Gasket Sealant {1302}
HDB Series and M1 Series Heavy Duty Brushless Alternators Rectifier - Test
3412E, C30 and C32 Marine Engines Engine Oil Filter Base - Disassemble
HDB Series and M1 Series Heavy Duty Brushless Alternators Stator - Test
3412E, C30 and C32 Marine Engines Engine Oil Filter Base - Install
3412E, C30 and C32 Marine Engines Engine Oil Filter Base - Remove
HDB Series and M1 Series Heavy Duty Brushless Alternators Capacitor - Test
3064 and 3066 Engines for Caterpillar Built Machines Engine Speed - Check
2001/08/01 When These Control Groups Are Used As Service Replacements, Use This Procedure For The Initial Setup Of The 203-7810 Engine Monitoring Control Group And The 203-7811 Engine Monitoring Control Group {1901, 7490}
2001/10/01 The Oil Pan No Longer Requires Gasket Sealant {1302}
3512 Industrial Engine Engine Oil Pan
G3600 Engines Engine Oil Temperature Regulator
G3600 Engines Ignition System
3408E and 3412E Industrial Engines Throttle Position Sensor - Calibrate
3126B Marine Engines Diagnostic Codes
3512B Marine Auxiliary Engine Vibration Sensor
SBF214 and SUF557 Skid Mounted Power Packs Maintenance Interval Schedule
2001/11/01 A New Temperature Indicator Assembly Is Available To Measure The Temperature Of The Air In The Air Inlet Manifold {1058, 7450}
SPS342 Skid Mounted Pumper Maintenance Interval Schedule