Engine Oil Filter Base - Install
Show/hide table
| Required Tools | |||
|---|---|---|---|
| Tool | Part Number | Part Description | Qty |
| A | 185-3630 | Strap Wrench As | 1 |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Position engine oil filter base (2) and install bolts (1) and (3).
- Install tube assembly (5).
- Install engine oil filters (4) with Tooling (A).
Show/hide table
| |
| Illustration 1 | g01082915 |
Caterpillar Information System:
3412E, C30 and C32 Marine Engines Engine Oil Filter Base - Remove
HDB Series and M1 Series Heavy Duty Brushless Alternators Capacitor - Test
G3600 Engines Aftercooler
HDB Series and M1 Series Heavy Duty Brushless Alternators Field Winding - Test
2001/08/01 Be Sure To Check The Counterweights On The Engine Crankshaft For Counterweight Sequence Numbers {1231}
3126B Marine Engines Sensors and Electrical Connectors
G3408C and G3412C Engines Balancer Group - Rear
HDB Series and M1 Series Heavy Duty Brushless Alternators Alternator - Assemble - M1 Series Alternator (35 Amp)
3512B Marine Auxiliary Engine Speed Control
3412E, C30 and C32 Marine Engines Exhaust Manifold - Remove and Install
TK711, TK721, TK722 and TK732 Track Feller Bunchers Seat Belt - Replace
3054 and 3056 Industrial and Generator Set Engines Maintenance Interval Schedule
HDB Series and M1 Series Heavy Duty Brushless Alternators Stator - Test
3412E, C30 and C32 Marine Engines Engine Oil Filter Base - Disassemble
HDB Series and M1 Series Heavy Duty Brushless Alternators Rectifier - Test
2001/08/01 Oil Pan No Longer Requires Gasket Sealant {1302}
2001/08/01 Additional Troubleshooting Procedures For Speed Burps {1901, 1913}
3412E, C30 and C32 Marine Engines Engine Oil Filter Base - Assemble
HDB Series and M1 Series Heavy Duty Brushless Alternators Residual Magnetism - Restore
2001/08/01 A New Piston and Piston Rings Are Now Available {1214, 1215}
120H and 135H Motor Graders Hydraulic and Steering System Control Valve (Snow Plow/Dozer Angle)
3126B Marine Engines ECM Will Not Communicate with Other Systems or Display Modules
3064 and 3066 Engines for Caterpillar Built Machines Engine Speed - Check
2001/08/01 When These Control Groups Are Used As Service Replacements, Use This Procedure For The Initial Setup Of The 203-7810 Engine Monitoring Control Group And The 203-7811 Engine Monitoring Control Group {1901, 7490}