Engine Oil Filter Base - Assemble
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install plunger (3).
- Install spring (2).
- Install cover (1).
- Install engine oil filter base (5) onto housing (4).
Show/hide table
Illustration 1 | g01083077 |
Show/hide table
Improper assembly of parts that are spring loaded can cause bodily injury. To prevent possible injury, follow the established assembly procedure and wear protective equipment. |
End By:
- Install the engine oil filter base. Refer to Disassembly and Assembly, "Engine Oil Filter Base - Install".
Caterpillar Information System:
2001/08/01 Additional Troubleshooting Procedures For Speed Burps {1901, 1913}
2001/08/01 Oil Pan No Longer Requires Gasket Sealant {1302}
HDB Series and M1 Series Heavy Duty Brushless Alternators Rectifier - Test
3412E, C30 and C32 Marine Engines Engine Oil Filter Base - Disassemble
HDB Series and M1 Series Heavy Duty Brushless Alternators Stator - Test
3412E, C30 and C32 Marine Engines Engine Oil Filter Base - Install
3412E, C30 and C32 Marine Engines Engine Oil Filter Base - Remove
HDB Series and M1 Series Heavy Duty Brushless Alternators Capacitor - Test
G3600 Engines Aftercooler
HDB Series and M1 Series Heavy Duty Brushless Alternators Field Winding - Test
2001/08/01 Be Sure To Check The Counterweights On The Engine Crankshaft For Counterweight Sequence Numbers {1231}
3126B Marine Engines Sensors and Electrical Connectors
HDB Series and M1 Series Heavy Duty Brushless Alternators Residual Magnetism - Restore
2001/08/01 A New Piston and Piston Rings Are Now Available {1214, 1215}
120H and 135H Motor Graders Hydraulic and Steering System Control Valve (Snow Plow/Dozer Angle)
3126B Marine Engines ECM Will Not Communicate with Other Systems or Display Modules
3064 and 3066 Engines for Caterpillar Built Machines Engine Speed - Check
2001/08/01 When These Control Groups Are Used As Service Replacements, Use This Procedure For The Initial Setup Of The 203-7810 Engine Monitoring Control Group And The 203-7811 Engine Monitoring Control Group {1901, 7490}
2001/10/01 The Oil Pan No Longer Requires Gasket Sealant {1302}
3512 Industrial Engine Engine Oil Pan
G3600 Engines Engine Oil Temperature Regulator
G3600 Engines Ignition System
3408E and 3412E Industrial Engines Throttle Position Sensor - Calibrate
3126B Marine Engines Diagnostic Codes