The Oil Pan No Longer Requires Gasket Sealant {1302}
- Engines:
- 3126 (S/N: 1ZJ1-UP; 6MK1-UP; 8NM1-UP; 3TR1-UP; 6SR1-UP; 9ZR1-UP; 6MS1-UP)
- 3126B (S/N: 9ZF1-UP; BEJ1-UP; 3GS1-UP)
- 3116 (S/N: 2WG1-UP; 5EN1-UP)
Reference: Disassembly and Assembly, SENR9518, "3114, 3116, and 3126 Industrial, Marine, and Generator Set Engines"
Reference: Disassembly and Assembly, SENR1142, "3126 HEUI Industrial Engine"
Reference: Disassembly and Assembly, RENR2249, "3126B Marine Engine"
Reference: Disassembly and Assembly, SENR9589, "3126B Industrial Engine"
The installation procedure has changed. Gasket sealant is no longer required when you install the oil pan. The service manuals that are referenced have been updated. Make a note of this change in your service manual.
Caterpillar Information System:
2001/08/01 When These Control Groups Are Used As Service Replacements, Use This Procedure For The Initial Setup Of The 203-7810 Engine Monitoring Control Group And The 203-7811 Engine Monitoring Control Group {1901, 7490}
3064 and 3066 Engines for Caterpillar Built Machines Engine Speed - Check
3126B Marine Engines ECM Will Not Communicate with Other Systems or Display Modules
120H and 135H Motor Graders Hydraulic and Steering System Control Valve (Snow Plow/Dozer Angle)
2001/08/01 A New Piston and Piston Rings Are Now Available {1214, 1215}
HDB Series and M1 Series Heavy Duty Brushless Alternators Residual Magnetism - Restore
3412E, C30 and C32 Marine Engines Engine Oil Filter Base - Assemble
2001/08/01 Additional Troubleshooting Procedures For Speed Burps {1901, 1913}
2001/08/01 Oil Pan No Longer Requires Gasket Sealant {1302}
HDB Series and M1 Series Heavy Duty Brushless Alternators Rectifier - Test
3412E, C30 and C32 Marine Engines Engine Oil Filter Base - Disassemble
HDB Series and M1 Series Heavy Duty Brushless Alternators Stator - Test
3512 Industrial Engine Engine Oil Pan
G3600 Engines Engine Oil Temperature Regulator
G3600 Engines Ignition System
3408E and 3412E Industrial Engines Throttle Position Sensor - Calibrate
3126B Marine Engines Diagnostic Codes
3512B Marine Auxiliary Engine Vibration Sensor
SBF214 and SUF557 Skid Mounted Power Packs Maintenance Interval Schedule
2001/11/01 A New Temperature Indicator Assembly Is Available To Measure The Temperature Of The Air In The Air Inlet Manifold {1058, 7450}
SPS342 Skid Mounted Pumper Maintenance Interval Schedule
2001/08/01 A Special Instruction Is Available For Replacing Starting Motor Solenoids {1467}
Electronic Modular Control Panel II (EMCP II) Fault Description
301.5, 301.6 and 301.8 Mini Hydraulic Excavators Engine Starting with Jump Start Cables