Vibration Sensor
Show/hide table
Illustration 1 | g00123133 |
Typical example |
- Install the engine speed sensor into the 5/8 threaded hole and turn until the magnetic core makes contact with the side of the flywheel.
- Back out 180 degrees and tighten the engine speed sensor to the following torque:
Torque for sensor ... 45 ± 7 N·m (33 ± 5 lb ft)
The clearance between the engine speed sensor and the flywheel ring gear is the following value: ... 0.56 to 0.84 mm (0.022 to 0.033 inch)
Caterpillar Information System:
3126B Marine Engines Diagnostic Codes
3408E and 3412E Industrial Engines Throttle Position Sensor - Calibrate
G3600 Engines Ignition System
G3600 Engines Engine Oil Temperature Regulator
3512 Industrial Engine Engine Oil Pan
2001/10/01 The Oil Pan No Longer Requires Gasket Sealant {1302}
2001/08/01 When These Control Groups Are Used As Service Replacements, Use This Procedure For The Initial Setup Of The 203-7810 Engine Monitoring Control Group And The 203-7811 Engine Monitoring Control Group {1901, 7490}
3064 and 3066 Engines for Caterpillar Built Machines Engine Speed - Check
3126B Marine Engines ECM Will Not Communicate with Other Systems or Display Modules
120H and 135H Motor Graders Hydraulic and Steering System Control Valve (Snow Plow/Dozer Angle)
2001/08/01 A New Piston and Piston Rings Are Now Available {1214, 1215}
HDB Series and M1 Series Heavy Duty Brushless Alternators Residual Magnetism - Restore
SBF214 and SUF557 Skid Mounted Power Packs Maintenance Interval Schedule
2001/11/01 A New Temperature Indicator Assembly Is Available To Measure The Temperature Of The Air In The Air Inlet Manifold {1058, 7450}
SPS342 Skid Mounted Pumper Maintenance Interval Schedule
2001/08/01 A Special Instruction Is Available For Replacing Starting Motor Solenoids {1467}
Electronic Modular Control Panel II (EMCP II) Fault Description
301.5, 301.6 and 301.8 Mini Hydraulic Excavators Engine Starting with Jump Start Cables
2001/09/01 Repair Procedure for the Threads in a Cylinder Head Casting that were Damaged by a Manual Valve Group (Kiene Valve) {1100}
C0.5, C0.7, C1.1/3011C, C1.5/3013C, C1.6 and C2.2/3024C/3024CT Industrial Engines and Engines for Caterpillar Built Machines Fuel Injection Lines
G3600 Engines Gas Engine Ignition
G3406 Engine Ignition System
G3406 Engine Ignition System
G3406 Engine Ignition Transformer