Fuel Injection Lines
Show/hide table
| |
| Illustration 1 | g00818680 |
(1) Tighten the union nuts for the fuel injector to the following torque.
- C0.5, C0.7 and C1.6 ...
20 N·m (14.75 lb ft)
- C1.1/3011C, C1.5/3013C, C2.2/3024C and C2.2/3024CT engines ...
23 N·m (17 lb ft)
(2) High pressure fuel supply line
(3) Low pressure fuel return line
(4) Tighten the banjo bolt to the following torque. ...
Show/hide table
| |
| Illustration 2 | g00818888 |
(5) Tighten the nut to the following torque. ...
(6) Washers for the fuel return line
(7) Washer for the fuel injector
(8) Washers for the banjo bolt
Note: All washers must be replaced when the fuel lines are removed.
Caterpillar Information System:
2001/09/01 Repair Procedure for the Threads in a Cylinder Head Casting that were Damaged by a Manual Valve Group (Kiene Valve) {1100}
301.5, 301.6 and 301.8 Mini Hydraulic Excavators Engine Starting with Jump Start Cables
Electronic Modular Control Panel II (EMCP II) Fault Description
2001/08/01 A Special Instruction Is Available For Replacing Starting Motor Solenoids {1467}
SPS342 Skid Mounted Pumper Maintenance Interval Schedule
2001/11/01 A New Temperature Indicator Assembly Is Available To Measure The Temperature Of The Air In The Air Inlet Manifold {1058, 7450}
SBF214 and SUF557 Skid Mounted Power Packs Maintenance Interval Schedule
3512B Marine Auxiliary Engine Vibration Sensor
3126B Marine Engines Diagnostic Codes
3408E and 3412E Industrial Engines Throttle Position Sensor - Calibrate
G3600 Engines Ignition System
G3600 Engines Engine Oil Temperature Regulator
G3600 Engines Gas Engine Ignition
G3406 Engine Ignition System
G3406 Engine Ignition System
G3406 Engine Ignition Transformer
3046 Engine for Caterpillar Built Machines Valve Guide - Inspect
Automatic Transfer Switches CTS, CTSD Series General Information
G3406 Engine Governor
2007/04/30 Maintenance Recommendations for the Crankshaft Vibration Dampers {1205}
G3408C and G3412C Engines Air/Fuel Ratio Control - Oxygen Feedback
G3406 Engine Gas Pressure Regulator
2001/09/01 A New Hose Assembly That Is Made From Stainless Steel Is Used In The Turbocharger Cleaner Groups {1052}
Electronic Modular Control Panel II (EMCP II) Electrical Converter (Pulse Width Modulated)