Governor Drive - Disassemble
Disassembly Procedure
Show/hide table
Required Tools     | |||
---|---|---|---|
Tool     | Part Number     | Part Description     | Qty     |
A     | 5P-0944     | Dowel Puller Group     | 1     |
B     | 1P-0510     | Driver Group     | 1     |
Start By:
- Remove governor drive. Refer to Disassembly and Assembly, "Governor Drive - Remove".
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove four bolts (1) .
Show/hide table
Illustration 1 | g00783882 |
- Remove bolts (2) and the washers.
- Remove cover (3) .
- Remove the remainder of bolts (4) .
Show/hide table
Illustration 2 | g00783890 |
- Remove two bolts (6) and service meter (5) .
- Make a separation of the two housings and remove five gears (7) .
Show/hide table
Illustration 3 | g00783895 |
- Remove shaft assembly (8) .
- Remove the dowel from shaft assembly (8) with Tooling (A) .
Show/hide table
Illustration 4 | g01422211 |
- Use a suitable press to remove gear (9) from shaft assembly (8) .
- Remove shafts (10) and bearings (11) from the housing.
Show/hide table
Illustration 5 | g00783896 |
- Remove bearings (12) from the housing, if necessary.
Show/hide table
Illustration 6 | g00783927 |
- Remove seals (13) .
Show/hide table
Illustration 7 | g00783929 |
Caterpillar Information System:
3412C Engine Turbocharger Oil Lines
3412C Engine Turbocharger
C-9 Industrial Engine Fan Drive - Install
3412C Engine Valve Mechanism Cover
G3408C and G3412C Engines Governor Drive - Install
Exhaust Temperature Scanner Worksheet
2001/04/01 New Air Shutoff Groups Are Used {1078}
G3408C and G3412C Engines Governor - Remove and Install
G3408C and G3412C Engines Governor Drive - Remove
2001/04/01 New Seventeen Character Product Identification Number (PIN) {7557}
G3408C and G3412C Engines Gas Pressure Regulator - Assemble
3412C Engine Fuel Filter Base
3126B Engine for Caterpillar Built Machines Engine Speed/Timing Sensor - Calibrate
XQ300, XQ400 Rental Generator Sets Self-Diagnostics
G3408C and G3412C Engines Governor Drive - Assemble
3412C Engine Aftercooler
G3408C and G3412C Engines Carburetor - Remove
G3408C and G3412C Engines Carburetor - Install
Product Identification Numbers (PIN) Location Guide Compactor (Soil)
G3408C and G3412C Engines Carburetor - Disassemble
3412C Engine Cylinder Block
37-MT, 41-MT, and 42-MT Series Starting Motors Engine Does Not Crank with Starting Motor On and Pinion Engaging Ring Gear
3412C Engine Engine Oil Pan
G3408C and G3412C Engines Carburetor - Assemble