Exhaust Temperature Scanner Caterpillar

Record the configuration parameters for your scanner in Table 1. Keep the record for future reference.

Table 1

Worksheet for the Configuration of the Scanner
Serial number		Site
Number of cylinders (1)		Number of turbochargers (1)
Turbocharger's Display (1)	Units (1)	"AUTOSCAN" (1)	Start-up Timer (1) (2)
"TO" and "TI"	°C or °F	ON/OFF	minutes
"TO" only	Filtering (1) (3)	Arming Temperature (1)
"TI" only	value	degrees
Setpoints and Temperatures (1)	"SETPOINTS ACTIVE W/ARM TEMP & TIMER" (4)	Output Switch 1 Configured (4)	Output Switch 2 Configured (4)
"CYL DEV"	Yes or No	Yes or No	Yes or No
"CYL HI 1"	Yes or No	Yes or No	Yes or No
"CYL HI 2"	Yes or No	Yes or No	Yes or No
"TO HI 1"	Yes or No	Yes or No	Yes or No
"TO HI 2"	Yes or No	Yes or No	Yes or No
"TI HI"	Yes or No	Yes or No	Yes or No
Status of Output Switch 1 (4)		Status of Output Switch 2 (4)
Normally open Normally closed		Normally open Normally closed
Latching Nonlatching		Latching Nonlatching

( 1 )	This parameter can be changed with the keypad.
( 2 )	The timer can be set from 1 minute to 30 minutes.
( 3 )	The minimum filtering is 1. the maximum filtering is 255.
( 4 )	This parameter cannot be changed with the keypad.