Fuel Filter Base
Show/hide table
 | |
| Illustration 1 | g00782739 |
(1) Place 154-9731 Thread Lock Compound on the tapered end of the stud to the following distance ... 7.6 ± 1.5 mm (0.30 ± 0.06 inch)
(2) Distance from the sealing surface of base to the end of stud ... 24.6 ± 1.3 mm (0.97 ± 0.05 inch)
(3) Sealing surface of stud
Note: Do not damage the sealing surface of the stud.
(4) Tighten the stud to the following torque. ... 70 ± 15 N·m (51 ± 11 lb ft)
Caterpillar Information System:
C-9 Industrial Engine Fan Drive - Remove
3412C Engine Engine Oil Filter
PM3516 Power Modules Control Panel
PM3516 Power Modules Alarms and Shutoffs
3126B Engine for Caterpillar Built Machines Injection Actuation Pressure Control Valve Circuit - Test
G3408C and G3412C Engines Gas Pressure Regulator - Disassemble
3412C Engine Engine Oil Filter Base
G3408C and G3412C Engines Gas Pressure Regulator - Install
G3408C and G3412C Engines Gas Pressure Regulator - Remove
3064 and 3066 Engines for Caterpillar Built Machines Piston Ring Groove - Inspect
C9 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Install
3412C Engine Exhaust Manifold
G3408C and G3412C Engines Gas Pressure Regulator - Assemble
2001/04/01 New Seventeen Character Product Identification Number (PIN) {7557}
G3408C and G3412C Engines Governor Drive - Remove
G3408C and G3412C Engines Governor - Remove and Install
2001/04/01 New Air Shutoff Groups Are Used {1078}
Exhaust Temperature Scanner Worksheet
G3408C and G3412C Engines Governor Drive - Install
3412C Engine Valve Mechanism Cover
C-9 Industrial Engine Fan Drive - Install
3412C Engine Turbocharger
3412C Engine Turbocharger Oil Lines
G3408C and G3412C Engines Governor Drive - Disassemble