Turbocharger
Show/hide table
Illustration 1 | g00783738 |
(1) V-band clamps
- Tighten the V-band clamps to the following torque. ... 14 ± 3 N·m (10 ± 2 lb ft)
- Gently tap around the V-band clamp with a soft faced hammer. Again tighten the V-band clamps to the following torque. ... 14 ± 3 N·m (10 ± 2 lb ft)
(2) Tighten the bolts to the following torque. ... 39 ± 2 N·m (29 ± 1.5 lb ft)
(3) Apply 5P-3931 Anti-Seize Compound on the washer face and the bolt threads before assembly. Tighten the bolts and nuts that hold the turbocharger to the exhaust manifold to the following torque. ... 55 ± 10 N·m (40 ± 7 lb ft)
Caterpillar Information System:
C-9 Industrial Engine Fan Drive - Install
3412C Engine Valve Mechanism Cover
G3408C and G3412C Engines Governor Drive - Install
Exhaust Temperature Scanner Worksheet
2001/04/01 New Air Shutoff Groups Are Used {1078}
G3408C and G3412C Engines Governor - Remove and Install
G3408C and G3412C Engines Governor Drive - Remove
2001/04/01 New Seventeen Character Product Identification Number (PIN) {7557}
G3408C and G3412C Engines Gas Pressure Regulator - Assemble
3412C Engine Fuel Filter Base
C-9 Industrial Engine Fan Drive - Remove
3412C Engine Engine Oil Filter
3412C Engine Turbocharger Oil Lines
G3408C and G3412C Engines Governor Drive - Disassemble
3126B Engine for Caterpillar Built Machines Engine Speed/Timing Sensor - Calibrate
XQ300, XQ400 Rental Generator Sets Self-Diagnostics
G3408C and G3412C Engines Governor Drive - Assemble
3412C Engine Aftercooler
G3408C and G3412C Engines Carburetor - Remove
G3408C and G3412C Engines Carburetor - Install
Product Identification Numbers (PIN) Location Guide Compactor (Soil)
G3408C and G3412C Engines Carburetor - Disassemble
3412C Engine Cylinder Block
37-MT, 41-MT, and 42-MT Series Starting Motors Engine Does Not Crank with Starting Motor On and Pinion Engaging Ring Gear