Compatibility Between The Attachment Controller Software, Electronic Technician (ET), And Monitor Software To The Standard Controller
Usage:
EXCAVATORS320C (AMC, BNC, BDC, BPR, CCD, GHA),
320C L (ANB, BBC, BDE, BER, BRX, HBC),
320C S (BBL),
320C LN (BEA),
320C U (CLM),
320C LU (CLZ),
322C (BLP),
322C L (BGR, BKJ, BKM),
322C LN (BFK),
325C (AMH, BKW),
325C L (BFE, BLX, BMM, BTD, CRB),
325C LN (CSJ),
330C (JAB, MCA),
330C L (CAP, CYA, DKY, GKX, KDD),
330 C LN (CGZ) EXCAVATORS
320C L (ANB, BBC, BDE, BER, BRX, HBC),
320C S (BBL),
320C LN (BEA),
320C U (CLM),
320C LU (CLZ),
322C (BLP),
322C L (BGR, BKJ, BKM),
322C LN (BFK),
325C (AMH, BKW),
325C L (BFE, BLX, BMM, BTD, CRB),
325C LN (CSJ),
330C (JAB, MCA),
330C L (CAP, CYA, DKY, GKX, KDD),
330 C LN (CGZ) EXCAVATORS
Problem:
The error message "ATT CONTROLLER NOT COMPATIBLE" will be displayed on the control monitor if the attachment controller software is not compatible with the standard controller.
Solution:
If attachment controller software is installed, it must be compatible with the standard controller. The Table that follows lists the compatibility between the attachment controller, the monitor, ET, and the standard controller software.
COPYRIGHT 2002 CATERPILLAR ALL RIGHTS RESERVED
Caterpillar Information System:
Installation Of A Four-Way Pilot Valve Group (Pattern Control Change) Installation Of A Four-Way Pilot Valve Group (Pattern Control Change)
Use Electronic Techmician (ET) To Cancel Logged Diagnostic Codes Use Electronic Techmician (ET) To Cancel Logged Diagnostic Codes
The 108-0358 Electronic Flasher Assembly Is Not A Drop-in Replacement For The 8D-6946 Flasher The 108-0358 Electronic Flasher Assembly Is Not A Drop-in Replacement For The 8D-6946 Flasher
Incorrect Part Numbers In The M315 Parts Manual Incorrect Part Numbers In The M315 Parts Manual
New Procedure To Install Pilot Pump Bearing Gear New Procedure To Install Pilot Pump Bearing Gear
Recall And Replacement Of SR17, SR18, And SR21 Snowblowers Recall And Replacement Of SR17, SR18, And SR21 Snowblowers
New Seal Kit Improves Sealing Of Main Pump Shaft New Seal Kit Improves Sealing Of Main Pump Shaft
A Loose Element In The Water Separator May Cause A Sporadic Loss Of Machine Power A Loose Element In The Water Separator May Cause A Sporadic Loss Of Machine Power
Increase The Setting Of The Pressure Relief Valve For The Snowblower's Auger Increase The Setting Of The Pressure Relief Valve For The Snowblower's Auger
Confusion Generated Due To The Same Serial Number Prefixes Being Used At Different Facilities Confusion Generated Due To The Same Serial Number Prefixes Being Used At Different Facilities
Dozer Blade Hydraulic Operation Options Dozer Blade Hydraulic Operation Options
The Actuator Rod In The Main Hydraulic Pump May Wear Prematurely The Actuator Rod In The Main Hydraulic Pump May Wear Prematurely
Reported Failures Of 110-4422 Rectifiers And 110-4424 Rectifiers On 3500-Series Generator Sets Reported Failures Of 110-4422 Rectifiers And 110-4424 Rectifiers On 3500-Series Generator Sets
Fuel Dilution Of The Oil In 3500B Engines Fuel Dilution Of The Oil In 3500B Engines
XT-6ES Hose Assemblies Have Increased Reliability And Durability In The Front Lines And The Pump Lines Groups XT-6ES Hose Assemblies Have Increased Reliability And Durability In The Front Lines And The Pump Lines Groups
Chute Deflector Drifts Down During Operation Of SR17, SR18, And SR21 Snowblowers Chute Deflector Drifts Down During Operation Of SR17, SR18, And SR21 Snowblowers
Excessive Vibration Experienced With SR18 And SR21 Snowblowers Excessive Vibration Experienced With SR18 And SR21 Snowblowers
Sidebar Retention Cotter Pin Failure Sidebar Retention Cotter Pin Failure
Improper Installation Of The 204-4024 Bracket Creates Unsafe Condition Improper Installation Of The 204-4024 Bracket Creates Unsafe Condition
Decal Of The Operating Pattern For The Hydraulic Controls Is Incorrect Decal Of The Operating Pattern For The Hydraulic Controls Is Incorrect
TITLE OF THE TIB TITLE OF THE TIB
Damage To The Bucket Cylinder Due To Excessive Pressure Damage To The Bucket Cylinder Due To Excessive Pressure
Machine Security System (MSS) Will Record Erroneous Events (Event 273) Machine Security System (MSS) Will Record Erroneous Events (Event 273)
Inspect the Check Valve in the Fuel Filter Base if You Have Starting Problems or if the Engine Runs Rough Inspect the Check Valve in the Fuel Filter Base if You Have Starting Problems or if the Engine Runs Rough