Incorrect Part Numbers In The M315 Parts Manual Caterpillar


Incorrect Part Numbers In The M315 Parts Manual

Usage:

WHEELED EXCAVATORSM315 (7ML) WHEELED EXCAVATORS

Problem:

Two of the part numbers in the SEBP2852 Parts Manual for the M315 Excavator are incorrectly identified. The parts list for the 137-2582 Lines Group-Diverter Valve has two part numbers that have been transposed.

Solution:

The corrected part numbers are identified in Table 1. Reference numbers 7 and 8 that now identify the correct part numbers.

Table 1

137-2582 LINES GP-DIVERTER VALVE

REF NO 7 145-4968 - Hose As
REF NO 8 145-4967 - Hose As

COPYRIGHT 2002 CATERPILLAR ALL RIGHTS RESERVED

Caterpillar Information System:

New Procedure To Install Pilot Pump Bearing Gear New Procedure To Install Pilot Pump Bearing Gear
Recall And Replacement Of SR17, SR18, And SR21 Snowblowers Recall And Replacement Of SR17, SR18, And SR21 Snowblowers
New Seal Kit Improves Sealing Of Main Pump Shaft New Seal Kit Improves Sealing Of Main Pump Shaft
A Loose Element In The Water Separator May Cause A Sporadic Loss Of Machine Power A Loose Element In The Water Separator May Cause A Sporadic Loss Of Machine Power
Increase The Setting Of The Pressure Relief Valve For The Snowblower's Auger Increase The Setting Of The Pressure Relief Valve For The Snowblower's Auger
Confusion Generated Due To The Same Serial Number Prefixes Being Used At Different Facilities Confusion Generated Due To The Same Serial Number Prefixes Being Used At Different Facilities
Dozer Blade Hydraulic Operation Options Dozer Blade Hydraulic Operation Options
The Actuator Rod In The Main Hydraulic Pump May Wear Prematurely The Actuator Rod In The Main Hydraulic Pump May Wear Prematurely
Parts Information For The New SR17, SR18, And SR21 Snowblowers Is Delayed Parts Information For The New SR17, SR18, And SR21 Snowblowers Is Delayed
V-Belt Failures And Engine Component Failures Due To Incorrect Belt Tension V-Belt Failures And Engine Component Failures Due To Incorrect Belt Tension
Modification Of The Switch Assembly For Sensing The Hydraulic Oil And Engine Oil Level Modification Of The Switch Assembly For Sensing The Hydraulic Oil And Engine Oil Level
The Actuator Rod In The Main Hydraulic Pump May Wear Prematurely The Actuator Rod In The Main Hydraulic Pump May Wear Prematurely
The 108-0358 Electronic Flasher Assembly Is Not A Drop-in Replacement For The 8D-6946 Flasher The 108-0358 Electronic Flasher Assembly Is Not A Drop-in Replacement For The 8D-6946 Flasher
Use Electronic Techmician (ET) To Cancel Logged Diagnostic Codes Use Electronic Techmician (ET) To Cancel Logged Diagnostic Codes
Installation Of A Four-Way Pilot Valve Group (Pattern Control Change) Installation Of A Four-Way Pilot Valve Group (Pattern Control Change)
Compatibility Between The Attachment Controller Software, Electronic Technician (ET), And Monitor Software To The Standard Controller Compatibility Between The Attachment Controller Software, Electronic Technician (ET), And Monitor Software To The Standard Controller
Reported Failures Of 110-4422 Rectifiers And 110-4424 Rectifiers On 3500-Series Generator Sets Reported Failures Of 110-4422 Rectifiers And 110-4424 Rectifiers On 3500-Series Generator Sets
Fuel Dilution Of The Oil In 3500B Engines Fuel Dilution Of The Oil In 3500B Engines
XT-6ES Hose Assemblies Have Increased Reliability And Durability In The Front Lines And The Pump Lines Groups XT-6ES Hose Assemblies Have Increased Reliability And Durability In The Front Lines And The Pump Lines Groups
Chute Deflector Drifts Down During Operation Of SR17, SR18, And SR21 Snowblowers Chute Deflector Drifts Down During Operation Of SR17, SR18, And SR21 Snowblowers
Excessive Vibration Experienced With SR18 And SR21 Snowblowers Excessive Vibration Experienced With SR18 And SR21 Snowblowers
Sidebar Retention Cotter Pin Failure Sidebar Retention Cotter Pin Failure
Improper Installation Of The 204-4024 Bracket Creates Unsafe Condition Improper Installation Of The 204-4024 Bracket Creates Unsafe Condition
Decal Of The Operating Pattern For The Hydraulic Controls Is Incorrect Decal Of The Operating Pattern For The Hydraulic Controls Is Incorrect
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.