Governor Control
Positive Lock
Show/hide table
Illustration 1 | g00596742 |
(1) Handle
Install the shaft of the handle. Tighten the shaft until the shaft reaches the plug. Tighten the shaft for three turns.
4W-2542 Spring is inside of the handle (1) .
Length under test force ... 53.3 mm (2.10 inch)
Test force ... 53.4 ± 4.3 N (12.0 ± 0.10 lb)
Free length after test ... 98 mm (3.86 inch)
Outside diameter ... 15.24 mm (0.60 inch)
Refer to the following steps in order to adjust the linkage.
- Place handle (1) in the upright position.
- Put lever (2) in the upright position. Use the hole in lever (2) as a guide in order to drill a 4.0 mm (0.16 inch) hole through the shaft. Install the pin in the shaft.
- Hold the governor in the Shutoff position. Refer to the illustration in order to install lever (4) .
- Adjust rod (3) to the length that is required. Install rod (3) between the levers.
Caterpillar Information System:
G3408 and G3412 Engines Governor
3116 and 3126 Marine Engines Turbocharger - Inspect
G3408 and G3412 Engines Magneto
G3408 and G3412 Engines Gas Pressure Regulator
G3408 and G3412 Engines Flywheel
3606 and 3608 Engines Restriction of Air Inlet and Exhaust
Generator Set Control Panel for Switchgear Conversion CID 0271 FMI 05 Alarm (Action) Current Below Normal - Test
3116 and 3126 Marine Engines Heat Exchanger - Inspect
Generator Set Control Panel for Switchgear Conversion CID 0271 FMI 03 Alarm (Action) Voltage Above Normal - Test
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install
G3408 and G3412 Engines Cylinder Liner
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Cooler Bypass Valve - Remove and Install
Generator Set Control Panel for Switchgear Conversion CID 0271 FMI 06 Alarm (Action) Current Above Normal - Test
G3408 and G3412 Engines Governor Linkage
Generator Set Control Panel for Switchgear Conversion CID 0263 FMI 04 Sensor Power Supply Voltage Below Normal - Test
Generator Set Control Panel for Switchgear Conversion Charging System - Test
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Install
Generator Set Control Panel for Switchgear Conversion Clear/Mode Switch - Troubleshoot
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Disassemble
3606 and 3608 Engines General Information (Lubrication System)
3408E and 3412E Engines for Caterpillar Built Machines Fuel Transfer Pump
3054 and 3056 Industrial and Generator Set Engines Engine Oil Cooler - Remove
Generator Set Control Panel for Switchgear Conversion Component Location
SR4 HV and SR4B HV Generators Before Starting Engine