CID 0271 FMI 03 Alarm (Action) Voltage Above Normal - Test
Show/hide table
Illustration 1 | g00565138 |
Schematic For The Alarm (Action) |
This diagnostic code is recorded when the Main Display Module reads the voltage of circuit for the Action Alarm as above normal or the voltage as shorted to +Battery. As a result of this diagnostic fault condition, the Action Alarm will sound continuously.
- Check The Alarm Circuit.
- Turn the ECS to the OFF/RESET position.
- Check for loose terminal connections or corroded terminal connections to the Action Alarm.
- Clean corroded terminals and tighten loose connections. Do Not disconnect the harness from the Caterpillar Monitoring System.
- Turn the ECS switch to the COOLDOWN/STOP position.
- Listen for the sounding of the Action Alarm.
Expected Result: The alarm should sound.
Results:
- OK: The alarm sounds. There is a short between the circuit for the Action Alarm and +battery in the engine harness.
- Not OK: The alarm does not sound. The Main Display Module has a problem. Replace the Main Display Module of the Caterpillar Monitoring System. For more information about this subject, see Testing And Adjusting, "Module - Replace".
- OK: The alarm sounds. There is a short between the circuit for the Action Alarm and +battery in the engine harness.
Caterpillar Information System:
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install
G3408 and G3412 Engines Cylinder Liner
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Cooler Bypass Valve - Remove and Install
Generator Set Control Panel for Switchgear Conversion CID 0263 FMI 03 Sensor Power Supply Voltage Above Normal - Test
Generator Set Control Panel for Switchgear Conversion Alert Indicator - Troubleshoot
3054 Engine for Caterpillar Built Machines Crankshaft Gear - Remove and Install
3054 Engine for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
Generator Set Control Panel for Switchgear Conversion Alarm Silence Switch - Troubleshoot
Generator Set Control Panel for Switchgear Conversion Alert Indicator Description
3408E and 3412E Engines for Caterpillar Built Machines Atmospheric Pressure Sensor - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Temperature Sensor - Remove and Install
3606 and 3608 Engines General Information (Fuel System)
3116 and 3126 Marine Engines Heat Exchanger - Inspect
Generator Set Control Panel for Switchgear Conversion CID 0271 FMI 05 Alarm (Action) Current Below Normal - Test
3606 and 3608 Engines Restriction of Air Inlet and Exhaust
G3408 and G3412 Engines Flywheel
G3408 and G3412 Engines Gas Pressure Regulator
G3408 and G3412 Engines Magneto
3116 and 3126 Marine Engines Turbocharger - Inspect
G3408 and G3412 Engines Governor
G3408 and G3412 Engines Governor Control
Generator Set Control Panel for Switchgear Conversion CID 0271 FMI 06 Alarm (Action) Current Above Normal - Test
G3408 and G3412 Engines Governor Linkage
Generator Set Control Panel for Switchgear Conversion CID 0263 FMI 04 Sensor Power Supply Voltage Below Normal - Test