Cylinder Liner
Show/hide table
Illustration 1 | g00118085 |
Note: Refer to Cylinder Liners in The Guideline For Reusable Parts SEBF8049 and SEBF8068.
Installation
- Put liquid soap on the liner bore surfaces of the cylinder block. Also, put liquid soap on the rubber seals which are installed on the lower part of the liner.
- Put the filler band completely in clean engine oil for a moment.
- Install filler band (3) in the groove under the liner flange without delay.
- Install the liner in the block immediately before the expansion of the filler band.
(1) Bore in new liner ... 137.19 ± 0.03 mm (5.401 ± 0.001 inch)
(2) Thickness of cylinder liner flange ... 8.89 ± 0.02 mm (0.3500 ± 0.0008 inch)
The minimum thickness that may be used again is the following value. ... 8.870 mm (0.3492 inch)
(3) Filler Band
Caterpillar Information System:
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Cooler Bypass Valve - Remove and Install
Generator Set Control Panel for Switchgear Conversion CID 0263 FMI 03 Sensor Power Supply Voltage Above Normal - Test
Generator Set Control Panel for Switchgear Conversion Alert Indicator - Troubleshoot
3054 Engine for Caterpillar Built Machines Crankshaft Gear - Remove and Install
3054 Engine for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
Generator Set Control Panel for Switchgear Conversion Alarm Silence Switch - Troubleshoot
Generator Set Control Panel for Switchgear Conversion Alert Indicator Description
3408E and 3412E Engines for Caterpillar Built Machines Atmospheric Pressure Sensor - Remove and Install
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Temperature Sensor - Remove and Install
3606 and 3608 Engines General Information (Fuel System)
3408E and 3412E Engines for Caterpillar Built Machines Electronic Control Module - Remove and Install
Generator Set Control Panel for Switchgear Conversion Action Alarm and Alarm Silence Switch
3408E and 3412E Engines for Caterpillar Built Machines Engine Oil Pan - Remove and Install
Generator Set Control Panel for Switchgear Conversion CID 0271 FMI 03 Alarm (Action) Voltage Above Normal - Test
3116 and 3126 Marine Engines Heat Exchanger - Inspect
Generator Set Control Panel for Switchgear Conversion CID 0271 FMI 05 Alarm (Action) Current Below Normal - Test
3606 and 3608 Engines Restriction of Air Inlet and Exhaust
G3408 and G3412 Engines Flywheel
G3408 and G3412 Engines Gas Pressure Regulator
G3408 and G3412 Engines Magneto
3116 and 3126 Marine Engines Turbocharger - Inspect
G3408 and G3412 Engines Governor
G3408 and G3412 Engines Governor Control
Generator Set Control Panel for Switchgear Conversion CID 0271 FMI 06 Alarm (Action) Current Above Normal - Test