Before Starting Engine
Inspect the engine for potential hazards.
Walk around the generator set before the engine is started. Ensure that no one is on the generator set. Also ensure that no one is underneath the generator set, or close to the generator set. Ensure that the area is free of personnel.
Ensure that the generator set is equipped with a lighting system that is suitable for the conditions. Ensure that all lights work properly.
See Service Manual for repairs and for adjustments.
Caterpillar Information System:
Generator Set Control Panel for Switchgear Conversion Component Location
3054 and 3056 Industrial and Generator Set Engines Engine Oil Cooler - Remove
3408E and 3412E Engines for Caterpillar Built Machines Fuel Transfer Pump
3606 and 3608 Engines General Information (Lubrication System)
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Disassemble
Generator Set Control Panel for Switchgear Conversion Clear/Mode Switch - Troubleshoot
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Install
Generator Set Control Panel for Switchgear Conversion Charging System - Test
Generator Set Control Panel for Switchgear Conversion CID 0263 FMI 04 Sensor Power Supply Voltage Below Normal - Test
G3408 and G3412 Engines Governor Linkage
Generator Set Control Panel for Switchgear Conversion CID 0271 FMI 06 Alarm (Action) Current Above Normal - Test
G3408 and G3412 Engines Governor Control
3054 Engine for Caterpillar Built Machines Housing (Front) - Remove
3054 Engine for Caterpillar Built Machines Housing (Front) - Install
3054 Engine for Caterpillar Built Machines Rocker Shaft and Pushrod - Remove
SR4 HV and SR4B HV Generators Walk-Around Inspection
3054 Truck Engine Rocker Shaft and Pushrod - Install
3054 Engine for Caterpillar Built Machines Rocker Shaft - Disassemble
Generator Set Control Panel for Switchgear Conversion Cycle Crank - Adjust
3408E and 3412E Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
3054 Engine for Caterpillar Built Machines Rocker Shaft - Assemble
Generator Set Control Panel for Switchgear Conversion Cycle Crank
3054 Truck Engine Cylinder Head - Remove - 3054 and 3054B Engines
3054 Truck Engine Cylinder Head - Install - 3054 and 3054B Engines