Rocker Shaft and Pushrod - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install eight pushrods (4) in the cylinder block.
Note: Ensure that the pushrods are installed in the original location and that the pushrods are seated in the valve lifters correctly.
Show/hide table
Illustration 1 | g00549956 |
- Install a new oil seal in the oil supply hole in the cylinder head.
- Install rocker shaft assembly (3) .
Note: Ensure that the adjustment screws are seated in the ends of pushrods (4) .
Show/hide table
Illustration 2 | g00549895 |
- Lubricate three nuts (1) and bolt (2) with clean engine oil.
- Install three nuts (1) and bolt (2) that holds rocker shaft assembly (3) on the cylinder head.
- Alternately tighten the nuts and the bolt. Start from the center and work toward the outside. Tighten the nuts and bolt on an aluminum bracket to a torque of 40 N·m (30 lb ft). Tighten the nuts and bolt on an cast iron bracket to a torque of 75 N·m (55 lb ft).
End By: Install the valve mechanism cover. Refer to Disassembly and Assembly, "Valve Mechanism Cover - Remove and Install".
Caterpillar Information System:
SR4 HV and SR4B HV Generators Walk-Around Inspection
3054 Engine for Caterpillar Built Machines Rocker Shaft and Pushrod - Remove
3054 Engine for Caterpillar Built Machines Housing (Front) - Install
3054 Engine for Caterpillar Built Machines Housing (Front) - Remove
SR4 HV and SR4B HV Generators Before Starting Engine
Generator Set Control Panel for Switchgear Conversion Component Location
3054 and 3056 Industrial and Generator Set Engines Engine Oil Cooler - Remove
3408E and 3412E Engines for Caterpillar Built Machines Fuel Transfer Pump
3606 and 3608 Engines General Information (Lubrication System)
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Disassemble
Generator Set Control Panel for Switchgear Conversion Clear/Mode Switch - Troubleshoot
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Install
3054 Engine for Caterpillar Built Machines Rocker Shaft - Disassemble
Generator Set Control Panel for Switchgear Conversion Cycle Crank - Adjust
3408E and 3412E Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
3054 Engine for Caterpillar Built Machines Rocker Shaft - Assemble
Generator Set Control Panel for Switchgear Conversion Cycle Crank
3054 Truck Engine Cylinder Head - Remove - 3054 and 3054B Engines
3054 Truck Engine Cylinder Head - Install - 3054 and 3054B Engines
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Assemble
G3408 and G3412 Engines Actuator Linkage
G3408 and G3412 Engines Carburetor Control Linkage
G3606 and G3608 Engines Engine Oil Pump - Install
G3408 and G3412 Engines Magnetic Pickup