Actuator Linkage
Turbocharged Engine
Show/hide table
Illustration 1 | g00579587 |
Top View |
Show/hide table
Illustration 2 | g00579589 |
(1) A typical control rod is shown in the illustration above. The control rod connects to the carburetor. On G3412 Engines, install the control rod on the outside of lever (2). On G3408 Engines, install the control rod on the opposite side of lever (2).
(2) Lever
In order to install the actuator lever, use the procedure that follows. Hold the control shaft in the shutoff position. Install lever (2) and tighten lever (2) to the shaft at angle (A) to the following values:
G3408 Engine ... 20 degrees
G3412 Engine ... 5 degrees
(3) Tighten the studs to the following torque. ... 14 ± 4 N·m (10 ± 3 lb ft)
Caterpillar Information System:
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Assemble
3054 Truck Engine Cylinder Head - Install - 3054 and 3054B Engines
3054 Truck Engine Cylinder Head - Remove - 3054 and 3054B Engines
Generator Set Control Panel for Switchgear Conversion Cycle Crank
3054 Engine for Caterpillar Built Machines Rocker Shaft - Assemble
3408E and 3412E Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install
Generator Set Control Panel for Switchgear Conversion Cycle Crank - Adjust
3054 Engine for Caterpillar Built Machines Rocker Shaft - Disassemble
3054 Truck Engine Rocker Shaft and Pushrod - Install
SR4 HV and SR4B HV Generators Walk-Around Inspection
3054 Engine for Caterpillar Built Machines Rocker Shaft and Pushrod - Remove
3054 Engine for Caterpillar Built Machines Housing (Front) - Install
G3408 and G3412 Engines Carburetor Control Linkage
G3606 and G3608 Engines Engine Oil Pump - Install
G3408 and G3412 Engines Magnetic Pickup
G3606 and G3608 Engines Engine Oil Pump - Disassemble
3054 Engine for Caterpillar Built Machines Pistons and Connecting Rods - Remove
G3408 and G3412 Engines Valve Cover
3054 Engine for Caterpillar Built Machines Pistons and Connecting Rods - Install
G3408 and G3412 Engines Cylinder Head Valves
3046 Engine for Caterpillar Built Machines Crankshaft Seals
3054 Engine for Caterpillar Built Machines Connecting Rod Bearings - Remove
3126 Truck Engine (Military) Engine Oil
3406E and 3456 Engines for Caterpillar Built Machines Front Housing and Covers