Magnetic Pickup For Actuator
 | |
| Illustration 1 | g00579596 |
Typical Example | |
(1) Gap between magnetic pickup and flywheel ring gear ... 0.56 to 0.76 mm (0.022 to 0.030 inch)
While the engine is not running, set the gap by turning the magnetic pickup. Turn the magnetic pickup until the magnetic pickup contacts a tooth of the flywheel ring gear.
Turn the magnetic pickup in the opposite direction for the following amount. ... one-half turn
(2) Tighten the locknut to the following torque. ... 25 ± 5 N·m (18 ± 4 lb ft)
(3) Install the sensor into the threaded hole. Turn the sensor until the sensor contacts the disc. Back out the sensor.
In order to create an air gap, back out the sensor.
Back out the sensor for the following amount. ... one-half turn ± one-tenth turn
The air gap should be equal to the following amount. ... 0.710 ± 0.140 mm (0.028 ± 0.060 inch)
Tighten the locknut to the following torque. ... 45 ± 7 N·m (33 ± 5 lb ft)