General Information (Lubrication System)
One of the problems in the list that follows will generally be an indication of a problem in the lubrication system for the engine.
- Lubrication metering pump for the inlet valve
- Excessive consumption of engine oil
- Low engine oil pressure
- High engine oil pressure
- Excessive bearing wear
- Increased engine oil temperature
Caterpillar Information System:
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Disassemble
Generator Set Control Panel for Switchgear Conversion Clear/Mode Switch - Troubleshoot
P16, P20, P25, P28, P40 and P60 Pulverizers Gerotor Motor - Install
Generator Set Control Panel for Switchgear Conversion Charging System - Test
Generator Set Control Panel for Switchgear Conversion CID 0263 FMI 04 Sensor Power Supply Voltage Below Normal - Test
G3408 and G3412 Engines Governor Linkage
Generator Set Control Panel for Switchgear Conversion CID 0271 FMI 06 Alarm (Action) Current Above Normal - Test
G3408 and G3412 Engines Governor Control
G3408 and G3412 Engines Governor
3116 and 3126 Marine Engines Turbocharger - Inspect
G3408 and G3412 Engines Magneto
G3408 and G3412 Engines Gas Pressure Regulator
3408E and 3412E Engines for Caterpillar Built Machines Fuel Transfer Pump
3054 and 3056 Industrial and Generator Set Engines Engine Oil Cooler - Remove
Generator Set Control Panel for Switchgear Conversion Component Location
SR4 HV and SR4B HV Generators Before Starting Engine
3054 Engine for Caterpillar Built Machines Housing (Front) - Remove
3054 Engine for Caterpillar Built Machines Housing (Front) - Install
3054 Engine for Caterpillar Built Machines Rocker Shaft and Pushrod - Remove
SR4 HV and SR4B HV Generators Walk-Around Inspection
3054 Truck Engine Rocker Shaft and Pushrod - Install
3054 Engine for Caterpillar Built Machines Rocker Shaft - Disassemble
Generator Set Control Panel for Switchgear Conversion Cycle Crank - Adjust
3408E and 3412E Engines for Caterpillar Built Machines Water Temperature Regulator - Remove and Install