Troubleshooting Chart
注: 座椅安全带具有 5 年的最大使用寿命。 此日期从出厂之日起开始。 关于正确的出厂日期,请参阅座椅安全带上的标签。 座椅安全带的安装寿命为 3 年。 请参阅座椅安全带上的安装贴纸或压印铝箔标签。
注: 机器维修时,检查座椅和座椅悬架有无松动。 每隔 1000 工时检查一次座椅。 根据需要,调整座椅。
注: 利用干膜润滑剂降低磨损并提供座椅悬架的平稳运行。 尤其在低温下,务必利用 1U-8268 干膜润滑剂 或 9U-6331 干膜润滑剂 保持操作的便捷性。 备用润滑剂为当地采购的透明有机硅气溶胶喷剂。
Show/hide table
故障诊断与排除     | |
故障现象     | 纠正     |
座椅上部     | |
横向松动     | 请参阅系统操作, "带系统空气的舒适空气悬架"。     |
座垫角度不能调整。 座位不正。     |
检查座椅并在必要时更换零件。 请参阅本手册拆解和组装部分内的对应主题。     |
腰部支撑不能调整。 腰部支撑位置不正。     |
检查座椅并在必要时更换零件。 请参阅本手册拆解和组装部分内的对应主题。     |
空气悬架     | |
悬架内松动     | 更换滚柱(如果配备)。 请参阅本手册拆解和组装部分内的对应主题。     |
座椅高度不能调整。     | 检查到电磁阀和/或空气管的连接。 请参阅拆解和组装部分内的对应主题。     |
减振性能不足     | 检查减振器和拉线。 必要时,更换减振器或拉线。 关于正确的程序,请参阅本手册拆解和组装部分内的对应主题。     |
座椅高度不能保持。     | 检查气囊和相关部件是否泄漏。 (1)     |
Show/hide table
( 1 ) | 如果每次换档时气囊放气,检查有无泄露。 气囊设计为至少在一个班次内保持充气。 |
注: 192-7848 减振器套件 可供体重超过 136 kg (300 lb) 的操作员或极端工作环境使用。 192-7848 减振器套件 是具有增强减振效果的双减振器套件。
Caterpillar Information System:
Comfort Series Seat For Caterpillar Machines Optimized Seat Controls
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Engine - Remove and Install
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Machine Preheater - Remove and Install
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Refrigerant Compressor - Remove and Install
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Muffler - Remove and Install
PM-200 Cold Planer Machine Systems Track Roller - Assemble
PM-200 Cold Planer Machine Systems Track Roller - Disassemble
PM-200 Cold Planer Machine Systems Track Roller - Install
PM-200 Cold Planer Machine Systems Track Roller - Remove
AP1000E Asphalt Paver Equipped with a Cat C6.6 Engine Hydraulic System Oil Filters - Replace
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Starting Aid (Air Inlet Heater) - Remove and Install
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Turbocharger - Remove and Install
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Hood Tilt Cylinder - Remove and Install
725C2 Articulated Truck Camera
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Hood Tilt Pump and Motor - Remove and Install
C4.4 Industrial Engine Fuel Filter Base - Single Secondary Fuel Filter Base
2011/04/01 A Troubleshooting Procedure Is Available for Implement Check and Relief Valve Group on Certain M and M Series 2 Motor Graders {4300, 5050}
2011/04/19 Updated Demand Fan Recalibration Information Available for Landfill Compactor, Wheel Dozer, and Wheel Loader Machines {1386, 1387}
SC-57 Felling Head Felling Head Piston Motor (Disc Saw)
924K, 930K and 938K Wheel Loaders Drive Shaft Spline - Lubricate - If Equipped
Field Installation of the 364-1356 Quick Coupler Conversion Kit (Hydraulic){6129} Field Installation of the 364-1356 Quick Coupler Conversion Kit (Hydraulic){6129}
2011/05/20 New Fuel Water Separator Bowls are Now Used on Certain Caterpillar Equipment {1261, 1263}
735B, 740B and 740B EJECTOR Articulated Trucks Engine Supplement Exhaust Elbow - Remove and Install
2011/03/29 New Water Temperature Regulator for C6.6 and C4.4 Machine Engines {1355, 1380, 1393}