Turbocharger - Remove and Install
Removal Procedure
Show/hide table
| Required Tools | |||
|---|---|---|---|
| Tool | Part Number | Part Description | Qty |
| A | 5P-3931 | Anti-seize Compound | 1 |
Show/hide table
 |
Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin. At operating temperature, the engine coolant is hot and under pressure. Steam can cause personal injury. Check the coolant level only after the engine has been stopped and the cooling system pressure cap is cool enough to touch with your bare hand. Remove the cooling system pressure cap slowly to relieve pressure. Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury. |
 |
- Remove cover (1) from the turbocharger.
Show/hide table
 | |
| Illustration 1 | g01125247 |
- Disconnect elbow (4), pipe (2) and hose (3) from the turbocharger.
Show/hide table
 | |
| Illustration 2 | g01016443 |
- Disconnect tube assemblies (5) and (6) .
Show/hide table
 | |
| Illustration 3 | g01016470 |
- Remove nuts (7) and remove turbocharger (8) .
Installation Procedure
- Install turbocharger (8) in the reverse order of removal.
- Use Tooling (A) when installing nuts (7). Tighten nuts (7) to a torque of 54 ± 5 N·m (40 ± 4 lb ft).
Caterpillar Information System:
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Reversible Fan - Assemble
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Reversible Fan - Disassemble
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Reversible Fan - Remove and Install
AP1055E and BG1055E Asphalt Pavers Equipped with a Cat C7.1 Engine Hydraulic System Oil Filters - Replace
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Refrigerant Condenser - Remove and Install
Command for Underground Glossary of Terms
Command for Underground Gate Proximity Switch - Test
Command for Underground Sensor (LADAR) - Configure - Area Isolation System (AIS)
Command for Underground Lanyard Switch - Test
Command for Underground Area Isolation System LADAR - Test
Command for Underground Service Tools
Command for Underground Electrical Connector - Inspect
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Starting Aid (Air Inlet Heater) - Remove and Install
AP1000E Asphalt Paver Equipped with a Cat C6.6 Engine Hydraulic System Oil Filters - Replace
PM-200 Cold Planer Machine Systems Track Roller - Remove
PM-200 Cold Planer Machine Systems Track Roller - Install
PM-200 Cold Planer Machine Systems Track Roller - Disassemble
PM-200 Cold Planer Machine Systems Track Roller - Assemble
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Muffler - Remove and Install
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Refrigerant Compressor - Remove and Install
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Machine Preheater - Remove and Install
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Engine - Remove and Install
Comfort Series Seat For Caterpillar Machines Optimized Seat Controls
Contour Series Seat Troubleshooting Chart