Hydraulic System Oil Filters - Replace
Show/hide table
Illustration 1 | g02480038 |
(1) Charge filter (2) Hydraulic oil level gauge (3) Hydraulic tank cap (4) Return filter |
Show/hide table
Illustration 2 | g02480176 |
(5) Material feed filter |
Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information on containing fluid spillage.
- Remove hydraulic tank cap (3) in order to relieve pressure from the hydraulic system.
- Remove the cover for the charge filter (1). Remove the charge filter.
- Remove the return filter cover (4). Remove the return filter.
- Remove material feed filter (5) .
- Install a new charge filter. Install the cover for the charge filter (1) .
- Install a new return filter. Install the return filter cover (4) .
- Install a new material feed filter (5) .
- Check the hydraulic oil level with oil level gauge (2). Maintain the oil level between the "FULL" mark and the "ADD" mark.
- Add additional oil if the oil level is below the "ADD" mark.
- Install hydraulic tank cap (3) .
Caterpillar Information System:
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Starting Aid (Air Inlet Heater) - Remove and Install
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Turbocharger - Remove and Install
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Reversible Fan - Assemble
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Reversible Fan - Disassemble
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Reversible Fan - Remove and Install
AP1055E and BG1055E Asphalt Pavers Equipped with a Cat C7.1 Engine Hydraulic System Oil Filters - Replace
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Refrigerant Condenser - Remove and Install
Command for Underground Glossary of Terms
Command for Underground Gate Proximity Switch - Test
Command for Underground Sensor (LADAR) - Configure - Area Isolation System (AIS)
Command for Underground Lanyard Switch - Test
Command for Underground Area Isolation System LADAR - Test
PM-200 Cold Planer Machine Systems Track Roller - Remove
PM-200 Cold Planer Machine Systems Track Roller - Install
PM-200 Cold Planer Machine Systems Track Roller - Disassemble
PM-200 Cold Planer Machine Systems Track Roller - Assemble
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Muffler - Remove and Install
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Refrigerant Compressor - Remove and Install
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Machine Preheater - Remove and Install
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Engine - Remove and Install
Comfort Series Seat For Caterpillar Machines Optimized Seat Controls
Contour Series Seat Troubleshooting Chart
541 Series 2 and 552 Series 2 Track Feller Bunchers Engine Supplement Hood Tilt Cylinder - Remove and Install
725C2 Articulated Truck Camera